Abstract:High speed impact experiments of a solution treated AM80 magnesium alloy were carried out with a large strain rate range based on split Hopkinson pressure bar (SHPB) technique, the applied strain rates were 700, 1100, 2150, 2750 and 3650 s?1, respectively. The results show that the flow stress of the studied AM80 magnesium alloy increase with increasing strain rate, demonstrating visible positive strain rate sensitivity. In addition, the flow stress increases significantly when the applied load transfers from quasi-static to dynamic. A Johnson-Cook dynamic constitutive equation isobtained by fitting the experimental stress?strain curves under various strain rates. The SHPB dynamic compressions of the material were simulated by using ABAQUS software with the fitted Johnson-Cook constitutive parameters. Calculated incident, reflected and transmitted waves were correlated with the stress?strain response of the solution treated AM80 samples using two-wave analytical method. The stress?strain curves at different strain rates obtained in the simulations were compared with the experimental and fittingstress?strain responses. The results show that the numerical simulation results and fitting results based on the Johnson-Cook strain-rate dependent constitutive model for the studied Mg alloy are basically in agreement with the experimental results, even the strain rate without in the range for constitutive fitting. Furthermore, an obviously large difference is detected at high strains as compared with that at low strains due to the neglect of local temperature rise under high strain rate loading.

Dynamic Crack Propagation Behavior of the Mg-Li Alloys under High-Speed Impact Loading

Mechanical properties and fracture behavior of Mg–3Al–1Zn alloy under high strain rate loading

High-Speed Impact Behavior and Microstructure Evolution of an Extruded Mg-7Sn-5Zn-3Al Alloy

Mechanical constitutive equation and simulation of AM80 magnesium alloy under high speed impact load

Research on Properties of Mg-Li Alloys

Dynamic mechanical response and deformation-induced co-axial nanocrystalline grains facilitating crack formation in magnesium-yttrium alloy

Crack initiation and propagation characteristics of a dual‐phase Mg–Li alloy under high‐cycle and very‐high‐cycle fatigue regimes

In-situ Study of Damage Mechanisms in Mg–6Li Dual-Phase Alloy

Microstructures, hot tensile deformation behavior and constitutive modeling in a superlight Mg-2.76Li-3Al-2.6Zn-0.39Y alloy

Deformation behavior and phase transformation of a dual-phase Mg−8.9Li−2.7Al-0.85Si alloy under compression test at elevated temperatures

The Deformation Mechanism and Adiabatic Shearing Behavior of Extruded Mg-8.0Al-0.1Mn Alloy in Different Heat Treated States under High-Speed Impact Load

Effect of Microstructures and Defects on Dynamic Compression and Shear Performance of Laser Metal-Deposited GH4169 Superalloy

Effect of Strain Rate and Temperature on Dynamic Mechanical Behavior and Microstructure Evolution of Ultra-High Strength Aluminum Alloy

The effect of T4 and T6 heat treatments for dynamic impact behavior of casting Mg-Gd-based alloys

Room-Temperature Microstructural Evolution of Extruded AM80 Magnesium Alloys under Dynamic Loading

Microstructure and Plastic Instability of Mg-4.3Li-1.08Y-5.83Zn Alloy

The microstructure evolution and deformation mechanism in a casting AM80 magnesium alloy under ultra-high strain rate loading

INFLUENCE OF LOADING RATE ON Al-Li ALLOY FRACTURE TOUGHNESS

Small fatigue crack growth in an extruded dual-phase Mg-Li alloy

Dynamic stress-strain behavior of AZ91 magnesium alloy and its dependence on strain rate

Dynamic deformation of Al under shock loading