Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Automotive Fire Simulation Based on Pyrosim

Apply numerical simulation method to chemical industry fire investigation

Numerical simulation study on bus fire

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Research and Analysis on Fire Simulation of Underground Pipe Gallery Based on Pyrosim Software

Simulation research on thermal protection performance of firefighting robots and design of protection system

Numerical Simulation of Fire in Underground Commercial Street

Fire simulation in house conditions

Application of Computational Simulation in Fire Science and Engineering Research

Numerical Simulation of Smoke Movement of Subway Fire under the Effect of Piston Wind

Simulation Design and Research of Flame Generation in Virtual Fire Scene Based on Unity3D

Numerical Reconstruction of a Building Fire and Smoke Hazard Evaluation

Numerical Simulation of Coupled Pyrolysis and Combustion Reactions with Directly Measured Fire Properties

Numerical Simulation for Special-typed Big Fires

Application Attempt of Virtual Simulation in "Smoke Control and Exhaust Engineering"

Experimental Study and Numerical Simulation for A Storehouse Fire Accident

A Virtual Reality Based Fire Training Simulator with Smoke Hazard Assessment Capacity

Numerical Simulation On Fire Suppression Modeling By Water Sprays

Experimental and Numerical Simulation Study of Typical Semi-Transparent Material Pyrolysis with In-Depth Radiation Based on Micro and Bench Scales

MATHEMATICAL MODELING OF FIRE DEVELOPMENT IN A THREE-STOREY RESIDENTIAL BUILDING DURING FULL-SCALE FIRE TESTS

Numerical Investigation of Fire Smoke Transport in the Tsinghua University Sports Center