Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Apply numerical simulation method to chemical industry fire investigation

Numerical Simulation for Special-typed Big Fires

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Simulation of temperature field of sintering ignition furnace

Numerical Simulation of Fire in Underground Commercial Street

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Numerical Study on the Fire Development Process of Typical Power Plant Multi-Floor Compartment

Numerical Simulation Analysis on Temperature Field for Large-space Structures under Fire

Three-dimensional numerical simulation of gas combustion in an industrial glass furnace

Study On Simulation Of The Building Fires Using An Advanced New Model

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Numerical Simulation of Multistory Building Fire with Zone—modeling Method

Research and Analysis on Fire Simulation of Underground Pipe Gallery Based on Pyrosim Software

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation of Coupled Pyrolysis and Combustion Reactions with Directly Measured Fire Properties

Numerical Simulation of Smoke Movement of Subway Fire under the Effect of Piston Wind

Numerical Investigation of Fire Smoke Transport in the Tsinghua University Sports Center

Integrated Application of Computer Technology in Building Fire Safety

Numerical Simulation of Contact Point Temperature Distribution and Fire Mechanism Analysis

3D numerical simulation of Texaco gasifier using assumed PDF model

Simulation Framework for Structural Safety in Building Fire