Abstract:The gap flow field formed by two rotating cylinders and the fiber orientation in the gap flow field are studied numerically. The finite volume method on the collocated body fitted grid is used for solving the field. On the assumption that there is no relative motion between the fibers and the fluid, the motion of the fibers is determined. The velocities of fibers are calculated by bi-linear interpolation method. The orientation of fibers is obtained by solving the Jeffery equation. Periodic boundary conditions are used for the fiber motion to ensure that the fibers keep staying in the computational area. Two cases i.e., two cylinders rotate in the opposite directions with the same speed and only the mandrel cylinder rotates, are considered. Physical quantities, such as velocity and pressure, for each case are obtained. For the first case, the velocity and pressure are completely symmetric about the mid-line of the computational area and the absolute values of the maximum and minimum velocity are equal due to the fact that both the casing and mandrel cylinders rotate at the same speed. The absolute values of the maximum and minimum pressure are not equal because the radii of the two cylinders are different. For the second case that only the mandrel cylinder rotates, the symmetries of the velocity and pressure about the mid-line of the computational area can also be found although the absolute values of the maximum and minimum velocity are not equal because of the different velocities of the two cylinders. Fiber motions and orientations at different times for both cases are captured. The twisting of fibers (matrix) can be observed vividly. For the case that the casing and the mandrel cylinders rotate in the opposite directions, fibers move and orientate in a two-layer structure. While for the case that only the mandrel cylinder rotates, fibers move and orientation in a single-layered structure. For both cases, the fibers have a strong tendency to align along the stream lines of the field. The influence of the slenderness ratio of fibers on fiber orientation is also studied. A stronger tendency to align along the stream lines of the field can be found as the slenderness ratio of fibers increases.

Dynamics of Sedimentation of Flexible Fibers in Moderate Reynolds Number Flows

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Dynamics of flexible fibers in confined shear flows at finite Reynolds numbers

Effect of Reynolds Number on the Fiber Orientation in a Suspension Flow Through a Slit Channel Containing a Cylinder

Dynamics of flexible fibers in viscous flows and fluids

Lattice Boltzmann Simulations of Sedimentation of A Single Fiber in A Weak Vertical Shear Flow

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

On the fully coupled dynamics of flexible fibres dispersed in modulated turbulence

Dynamic Simulation of Fiber Orientation in the Gap Flow Field Between Two Rotating Cylinders

Coarse-graining the dynamics of immersed and driven fiber assemblies

A successive iteration method on predicting properties of turbulent fiber suspensions and its application to pipe flows

Fiber Orientation Distributions in Slit Channel Flows with Abrupt Expansion for Fiber Suspensions

Mathematical modeling of turbulent fiber suspension and successive iteration solution in the channel flow

Research on the Motion of Particles in the Turbulent Pipe Flow of Fiber Suspensions

Numerical Research on the Orientation Distribution of Fibers Immersed in Laminar and Turbulent Pipe Flows

STABILITY IN THE CIRCULAR PIPE FLOW OF FIBER SUSPENSIONS

Hydrodynamic Instability of Fiber Suspensions in Channel Flows

Rheological behavior of fiber suspensions in a turbulent channel flow.

The sedimentation of flexible filaments