Abstract:To study the mechanism of the photo-thermochemical cycle (PTC), titanium dioxide (ST) and Ni-doped TiO2 (NT) films were produced using a sol-gel method and applied in the PTC for CO2 reduction. And commercial P25 (PT) has been used as a compared sample. A comparison of CO production shows that Ni-doped TiO2 performed better than undoped TiO2 and P25. Average CO production of NT PTCs was 5.30 punolig-cat and it was nearly 3.13 times of ST PTCs' CO production and 2.28 times of PT PTCs'. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy -dispersive X-ray spectroscopy (EDXS) and X-ray diffraction (XRD) were used to assess the crystal structure and morphology of the films. Ni element could be found in NT by EDXS and inductively coupled plasma-atomic emission spectrometry (ICP-AES), and the mass fraction of Ni was 0.54% and 0.436% which were agreed with experiments. This result of XRD indicated that Ni2+ may have high dispersion without significant change in TiO2 and Ni2+ ions were doped into the TiO2 lattice so that Ni-O-Ti bonds were formed. Photoluminescence (PL), time-resolved PL, UV-visible diffuse reflectance spectra (UV-visible DRS) and X-ray photoelectron spectroscopy (XPS) analyses were also conducted to investigate the charge transfer and reaction mechanisms on the sample surface. The incorporation of Ni into TiO2 resulted in a weaker PL intensity than that of bare TiO2, which suggests that the introduction of Ni into TiO2 effectively suppressed the undesirable recombination of electrons and holes. According to UV-visible DRS results, the E, of PT is approximately 3.07 eV, which is smaller than that of ST (E-g=3.23 eV) and PT (E-g= 3.20 eV). The narrower band gap of NT indicates that NT absorbed light with a wider wavelength range than that absorbed by ST and PT. By XPS patterns, the increase of Ni+/0 and Ti3+ indicated that the Vo may have been produced on the bond of Ni-O-Ti after UV illumination, and oxygen vacancies (Vo) have been consumed after thermal step in PTC. Density functional theory (DFT) calculations related to the anatase (101) surface of TiO2 and Ni doped TiO2 was performed to verify and provide guidance for enhancing the PTC mechanism. Single and second Vo formation energy have been calculated. The Ni-doped surface exhibits better performance than the undoped surface in the first step in PTC, because of its lower Vo formation energy which produce more Vo sites. Density of states (DOS) and partial density of states (PDOS) results indicated that narrow energy gap and impurity energy level of Ni-doped TiO2 may lead to a wider wavelength range of NT. As a result, several key factors of the mechanism have been clarified.

Enhanced Solar Conversion of CO2 to CO Using Mn‐doped TiO2 Based on Photo‐thermochemical Cycle

Guiding Effective Nanostructure Design for Photo-Thermochemical CO2 Conversion: from DFT Calculations to Experimental Verifications

Photothermal Coupling Factor Achieving CO2 Reduction Based on Palladium-Nanoparticle-Loaded TiO2

Visible Light-Responding Perovskite Oxide Catalysts for Photo-Thermochemical CO2 Reduction

Photo-thermochemical Cycle for CO2 Reduction Based on Effective Ni Ion Substitute-doped TiO2

Exceptional Co-Catalyst Free Photocatalytic Activities of B and Fe Co-Doped SrTiO3 for CO2 Conversion and H2 Evolution

Photoinduced Reaction Pathway Change for Boosting CO 2 Hydrogenation over a MnO-Co Catalyst

Efficient Conversion of CO2 to Methane Photocatalyzed by Conductive Black Titania

Magnetic-Field-Regulated TiO2 {100} Facets: A Strategy for C-C Coupling in CO2 Photocatalytic Conversion

Improved Charge Separation and Surface Activation Via Boron-Doped Layered Polyhedron SrTiO3 for Co-Catalyst Free Photocatalytic CO2 Conversion

Constructing C-doped TiO<sub>2</sub>/-Bi<sub>2</sub>O<sub>3</sub> hybrids Z-scheme heterojunction for enhanced CO<sub>2</sub> photoreduction

Constructing C-doped TiO2/β-Bi2O3 hybrids Z-scheme heterojunction for enhanced CO2 photoreduction

Enhanced mechanism of the photo-thermochemical cycle based on effective Fe-doping TiO2 films and DFT calculations

Construction of Visible-Light-Responsive SrTiO3 with Enhanced CO2 Adsorption Ability: Highly Efficient Photocatalysts for Artifical Photosynthesis

Hydrogenated Blue Titania for Efficient Solar to Chemical Conversions: Preparation, Characterization, and Reaction Mechanism of CO2 Reduction

TiO2/MXene Ti3C2 Composite with Excellent Photocatalytic CO2 Reduction Activity

Tailoring the oxidation state of metallic TiO through Ti3+/Ti2+ regulation for photocatalytic conversion of CO2 to C2H6

Regulating Photocatalytic CO2 Reduction Kinetics through Modification of Surface Coordination Sphere

2D copper‐porphyrin MOF nanosheets‐photosensitized TiO2 for efficiently broad band light driven conversion of CO2 to CH4

Rational fabrication of cadmium-sulfide/graphitic-carbon-nitride/hematite photocatalyst with type II and Z-scheme tandem heterojunctions to promote photocatalytic carbon dioxide reduction

Atomic Interface Engineering of Single‐Atom Pt/TiO2‐Ti3C2 for Boosting Photocatalytic CO2 Reduction