Abstract:To study the mechanism of the photo-thermochemical cycle (PTC), titanium dioxide (ST) and Ni-doped TiO2 (NT) films were produced using a sol-gel method and applied in the PTC for CO2 reduction. And commercial P25 (PT) has been used as a compared sample. A comparison of CO production shows that Ni-doped TiO2 performed better than undoped TiO2 and P25. Average CO production of NT PTCs was 5.30 punolig-cat and it was nearly 3.13 times of ST PTCs' CO production and 2.28 times of PT PTCs'. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy -dispersive X-ray spectroscopy (EDXS) and X-ray diffraction (XRD) were used to assess the crystal structure and morphology of the films. Ni element could be found in NT by EDXS and inductively coupled plasma-atomic emission spectrometry (ICP-AES), and the mass fraction of Ni was 0.54% and 0.436% which were agreed with experiments. This result of XRD indicated that Ni2+ may have high dispersion without significant change in TiO2 and Ni2+ ions were doped into the TiO2 lattice so that Ni-O-Ti bonds were formed. Photoluminescence (PL), time-resolved PL, UV-visible diffuse reflectance spectra (UV-visible DRS) and X-ray photoelectron spectroscopy (XPS) analyses were also conducted to investigate the charge transfer and reaction mechanisms on the sample surface. The incorporation of Ni into TiO2 resulted in a weaker PL intensity than that of bare TiO2, which suggests that the introduction of Ni into TiO2 effectively suppressed the undesirable recombination of electrons and holes. According to UV-visible DRS results, the E, of PT is approximately 3.07 eV, which is smaller than that of ST (E-g=3.23 eV) and PT (E-g= 3.20 eV). The narrower band gap of NT indicates that NT absorbed light with a wider wavelength range than that absorbed by ST and PT. By XPS patterns, the increase of Ni+/0 and Ti3+ indicated that the Vo may have been produced on the bond of Ni-O-Ti after UV illumination, and oxygen vacancies (Vo) have been consumed after thermal step in PTC. Density functional theory (DFT) calculations related to the anatase (101) surface of TiO2 and Ni doped TiO2 was performed to verify and provide guidance for enhancing the PTC mechanism. Single and second Vo formation energy have been calculated. The Ni-doped surface exhibits better performance than the undoped surface in the first step in PTC, because of its lower Vo formation energy which produce more Vo sites. Density of states (DOS) and partial density of states (PDOS) results indicated that narrow energy gap and impurity energy level of Ni-doped TiO2 may lead to a wider wavelength range of NT. As a result, several key factors of the mechanism have been clarified.

Enhanced mechanism of the photo-thermochemical cycle based on effective Fe-doping TiO2 films and DFT calculations

Effects of the Conjugated Structure of Fe–bipyridyl Complexes on Photoinduced Electron Transfer in TiO2 Photocatalytic Systems

Photo-thermal Coupling Water Splitting over Fe-doped TiO2 with Various Nanostructures

Inductive effect of Ti-doping in Fe2O3 enhances the photoelectrochemical water oxidation

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Effect of Fe doping on crystalline phase, structure and photocatalytic properties of TiO2 thin films

Guiding Effective Nanostructure Design for Photo-Thermochemical CO2 Conversion: from DFT Calculations to Experimental Verifications

Direct Hydro-Alcohol Thermal Synthesis of Special Core–shell Structured Fe-doped Titania Microspheres with Extended Visible Light Response and Enhanced Photoactivity

Unraveling Active Sites Regulation and Temperature-Dependent Thermodynamic Mechanism in Photothermocatalytic CO2 Conversion with H2O

Highly Enhanced Photoelectrocatalytic Properties by Α-Fe 2 O 3 Modified NF-TiO 2 Pyramids with Dominant (101) Facets

Interface Engineering of CoFe-LDH Modified Ti: α-Fe2O3 Photoanode for Enhanced Photoelectrochemical Water Oxidation

Enhanced Photoelectrochemical Oxidation of Water over Ti-Doped Α-Fe2o3 Electrodes by Surface Electrodeposition InOOH

Surface defect engineering of Fe-doped Bi7O9I3 microflowers for ameliorating charge-carrier separation and molecular oxygen activation

Photothermal Coupling Factor Achieving CO2 Reduction Based on Palladium-Nanoparticle-Loaded TiO2

Effects of Transition Metal Doping on Electronic Structure of Metastable Β-Fe2o3 Photocatalyst for Solar-to-hydrogen Conversion.

Synergistic effects of carbon doping and coating of TiO2 with exceptional photocurrent enhancement for high performance H2 production from water splitting

Selective Doping of Titanium into Double Layered Hematite Nanorod Arrays for Improved Photoelectrochemical Water Splitting

Study on the mechanisms of photoinduced carriers separation and recombination for Fe3+–TiO2 photocatalysts

Photo-thermochemical Cycle for CO2 Reduction Based on Effective Ni Ion Substitute-doped TiO2

F and Fe co-doped TiO 2 with enhanced visible light photocatalytic activity

Enhanced Solar Conversion of CO2 to CO Using Mn‐doped TiO2 Based on Photo‐thermochemical Cycle