Abstract:The static drill rooted nodular (SDRN) pile is a new type of composite pile that consists of a precast pile and surrounding cemented soil. Its cost advantages and environmentally friendly construction have been proven in applications in Southeast China. Moreover, the composition of pipe pile and nodular pile is based on the load transfer mechanisms of a pile foundation, which is effective in optimal design. This paper presents a field study on the behavior of SDRN piles under compression. The load-displacement response, axial force, mobilized load of pile cap, skin friction, and tip resistance of the composite pile are discussed. Here, the bilinear base load-displacement model was adopted to analyze the test results. It is found that providing caps on the static drill rooted piles takes full advantage of the static drill rooted method, and drilling and grouting into the soil beneath the cap, which can be considered a type of ground improvement treatment, can increase the bearing capacity of the pile cap; thus, setting a pile cap for this type of piles is recommended. The existence of the caps in the field tests decreased the skin friction of the upper part of pile shaft because of the additional settlement of the surrounding soil, which developed owing to the pressure from the caps. The frictional capacity of the concrete-cemented soil interface was much higher than that of the cemented soil-soil interface. The skin friction of the lower part of the pile shaft was about 1.25 times in clayey soil and 2.0 times in sandy soil compared with the bored pile. It can be concluded that the cemented soil-soil interface of the SDRN pile was probably better than the concrete-soil interface of the bored pile. The test results fitted the first stage curve of the bilinear model well, and it can be supposed that the base soil was strengthened because of the permeation of the cement paste.

Effect of Spatial Correlation of Cone Tip Resistance on the Bearing Capacity of Piles

Design Method Reliability Assessment from an Extended Database of Axial Load Tests on Piles Driven in Sand

Assessment of design methods for axial bearing capacity of driven piles in clay

A New and Openly Accessible Database of Tests on Piles Driven in Sands

Effect of Spatial Correlation of Standard Penetration Test (spt) Data on Bearing Capacity of Driven Piles in Sand

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Influence of Correlation Distance of Soil Parameters on Pile Foundation Failure Probability

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

Field Test on the Influence of the Cemented Soil Around the Pile on the Lateral Bearing Capacity of Pile Foundation

A test on base bearing capacity of static drill rooted nodular pile

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Assessment of Cohesive Soil Landslide Driving Forces Exerted on Piles Considering Soil Arching Effects

Bearing capacity analysis of offshore pipe piles with CPTs by considering uncertainly

Analysis of the End-Bearing Capacity of Piles in Sand under Limited Region Failure by a Mixed Zero-Extension Line Method

Estimation of the installation torque-capacity correlation of helical pile considering spatially variable clays

Bearing capacity of constrained grouting expansion bored pile based on CPTU and expansion tests

The Bearing Capacity of Spudcan Foundations under Combined Loading in Spatially Variable Soils

Study on the Bearing Capacity of Concrete-Cored DCM Pile Composite Foundation

Bearing Capacity of Concrete-Cored Dcm Pile Composite Ground