Abstract:Spline connection is a key component for force- and torque-transmission, which is widely used in mechanical engineering. External splines in spline connection have been manufactured by rolling process, but the matched inner splines manufactured by plastic deformation are few. Especially, the long inner spline is usually manufactured by cutting process. The rolling process is a plastic forming process with local loading and force saving; so, this study investigated the rolling process and its implementing way for inner spline sleeve. A radial-feed rolling process and two through-feed rolling processes with different structure of entry-angle section were proposed, and the finite element (FE) models were established for different rolling process, respectively. For the FE model of the through-feed rolling process, a multiple meshing strategy is used such as the local refinement window moving along axial direction with rolling die and the total number of mesh increasing by stages. The results indicated that the contact area is the same along axial direction and increases in situ during radial-feed rolling process, but the contact area changes and moves along axial direction during through-feed rolling process; the full and clear shape of inner spline can be obtained by the three rolling processes, but the shapes near the end of expected zone with inner spline are different for the different processes, and the geometry near the end of billet and the rolling process have the influence on the shapes near the end; some metal is accumulated in front of the through-feed rolling die, so non-full teeth present in the entered end by the rolling die and full teeth in the exited end will be out of the expected zone with inner spline.

The flow forming process simulated by finite element method

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Metal flowing of involute spline cold roll-beating forming

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Simulation Study on the High-Speed Single-Point Accumulation Forming Process of Involute Spline

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Numerical Simulation of Stagger Spinning of Cylindrical Part with Cross Inner Ribs

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

Numerical Simulation of Double Rollers Clamping Spinning Process for Flanging

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Acceleration of sheet metal spinning simulation by multi-mesh method

Finite element synthesized analysis of the forming process of spiral welded pipe

Simulation of Roll Forming with Dynamic Explicit Finite Element Method

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Research on a multi-step spinning process for manufacturing disc-like part with thickened rim

Recess Swaging Method for Manufacturing the Internal Helical Splines

New method for forming shaft having thread and spline by rolling with round dies

Controlling Flow Instability in Straight Spur Gear Forging Using Numerical Simulation and Response Surface Method