Abstract:In part I, we studied thermal explosions in systems with distributed temperatures, and more particularly the evolution of reactant temperatures in time. Reactant consumption, however, was ignored. Here we consider the influence of reactant consumption for the whole range of Biot number from the Semenov extreme (β = 0) to the Frank-Kamenetskii extreme (β → ∞). We concentrate on numerical results for the three simplest geometries (infinite slab, infinite cylinder and sphere), but our route is valid for arbitrary geometry. Earlier treatments in this field are extended by considering not only generalized temperature-dependences of reaction rate,f(θ), but also generalized concentration-dependences of reaction rate, g(w). An important influence of reactant consumption is to modify the critical value for the Frank-Kamenetskii parameter δ, δcr/δ0 = 1 + ϕ(gw/B)⅔, where the coefficient ϕ depends on the geometry, gw represents an effective order of reaction (to be evaluated at initial temperature and concentration), B is a dimensionless adiabatic temperature rise and δ0 is the critical value of δ when reactant consumption is ignored (B → ∞). The value of the constant ϕ is readily calculated from certain simple integrals. Its dependence on geometry and its variation with Biot number β are presented and discussed. It is shown that for β → ∞, reactant consumption has a smaller effect on the critical behaviour than in the case where β = 0, and the same trend is found for intermediate values of β. The role of diffusion of reactant is examined. It is found that the behaviour, as gauged by the leading-order terms of an asymptotic analysis, falls into one of two classes, so that diffusion either may be entirely ignored or is so rapid that concentrations are uniform. Results for the two classes show a remarkably close correspondence and permit a uniform treatment. Results are given for the time taken by a system either to ignite or, otherwise, to reach a maximum temperature. For important limiting cases simple asymptotic formulae are given for these times; they constitute good approximations over wide ranges. For moderately supercritical systems the time to ignition, tign, differs by little from the ignition time tign(B → ∞) for the case of zero reactant consumption: tign/tign (B → ∞) = 1+G(gw/B) (δ-δ0/δ)-3/2 +O(gw/B)2. For the Arrhenius temperature dependence with large activation energy the constant G is about unity for all cases.

Estimation of Critical Temperature of Thermal Explosion for Energetic Materials Based on Non-isothermal Kinetic Equation d alpha/dt=A(0)exp(bT)[1+(T-T-0)b]f(alpha)

The Estimation of Critical Temperatures of Thermal Explosion for Energetic Materials Using Non-Isothermal DSC

Method to Determine the Kinetic Parameters of the Autocatalytic Decomposition Reaction and Critical Rate of Temperature Rise of Thermal Explosion of Energetic Materials from DSC Curves

Estimation of Critical Temperature of Thermal Explosion for Nitrosubstituted Azetidines Using Non‐isothermal DSC

Dsc Analysis Methods To Determine Autoignition Temperature Of Energetic Materials

Mathematic expression of kinetic compensation effect and relationship between the exothermic decomposition temperature and critical temperature of thermal explosion of eighty-six energetic materials

Non-isothermal Decomposition Kinetics, Heat Capacity and Thermal Safety of 37.2/44/16/2.2/0.2/0.4-Gap/cl-20/al/n-100/pca/auxiliaries Mixture.

A study on the critical ambient temperature for the thermal explosion of explosive cylinders

Thermal Explosions, Criticality and the Disappearance of Criticality in Systems with Distributed Temperatures .1. Arbitrary Biot-Number and General Reaction-Rate Laws

Critical parameters of thermal explosion problem of exothermic materials with shells

Prediction of Thermal Safety of Energetic Materials

Thermal Explosion, Times to Ignition and Near-Critical Behaviour in Uniform-Temperature Systems. Part 3.—effects of Variable Heat-Transfer Coefficients

Thermal Explosions, Criticality and the Disappearance of Criticality in Systems with Distributed Temperatures. II. an Asymptotic Analysis of Critically at the Extremes of Biot Number (( Bi ) -> 0, ( Bi ) -> ∞ for Generalized Reaction Rate-Laws

Non-Isothermal Decomposition Kinetics, Heat Capacity, and Thermal Safety of 2-Nitroimino-5-nitro-hexahydro-1,3,5-triazine (Nnht)

Critical parameters for the thermal explosion of exothermic systmes having two-dimensional geometries

Thermal Explosion and the Theory of Its Initiation by Steady Intense Light

Thermal Explosions, Criticality and the Disappearance of Criticality in Systems with Distributed Temperatures III. Asymptotic Analysis of the Disappearance of Criticality (transition) at the Extreme of Small Biot Number

Testing and evaluation of the thermal damage caused by an explosion of energetic materials

Research on the Mechanical Stimulation Response and Thermal Effects Simulation of Energetic Materials

The Role of Two Models of Thermal Radiation and Variable Properties on Thermal Explosion Critical and Transition Conditions of the Optically Thin Droplets

Thermal Explosion and Times-to-ignition in Systems with Distributed Temperatures Il. the Influence of Reactant Consumption