Preparation of Hydrophilic Epoxy Resin and Its Wettability Regulation

Yihao Qian,Dongjie Zhang,Zhongjun Cheng,Hongjun Kang,Yuyan Liu
DOI: https://doi.org/10.7503/cjcu20180174
2018-01-01
Abstract:hydrophilic shape memory epoxy resin was prepared by introducing polyethylene glycol (PEG) into the 4,5-epoxy cyclohexane-1,2-2-phthalate glycidyl ester(TDE-85) epoxy/m-phenylenediamine (MXDA) system, meanwhile, its surface wettability could be controlled by changing its pillar structure under external thermal-stimuli. The result shows that the introduction of PEG effectively increases the hydrophilicity of TDE-85 epoxy resin, and the optimal amount of PEG is 20% (mass fraction). In this condition, the water contact angle is about 54 degrees, indicating the realization of wetting conversion from the original hydrophobic TDE-85 epoxy resin/MXDA curing system(water contact angle is about 108 degrees) to the hydrophilic TDE-85/MXDA/PEG system. The T, of the obtained material is 71 degrees C, and its shape fixed ratio and recovery ratio are 96. 10% and 99. 97%, respectively, meaning that the obtained material has a good shape memory property. The micropillars onto the surface by the template method, reversible wetting switching between the hydrophilicity (51 degrees) and the superhydrophilicity (0 degrees) can be realized based on the shape memory ability.
What problem does this paper attempt to address?