A Direct Displacement-Based Seismic Design Method Using a MDOF Equivalent System: Application to R/C Framed Structures

Edmond V. Muho,Jiang Qian,Dimitri E. Beskos

DOI: https://doi.org/10.1007/s10518-020-00857-5

IF: 4.556

2020-01-01

Bulletin of Earthquake Engineering

Abstract:An improved version of the direct displacement-based design (DDBD) method for the seismic design of plane moment resisting frames in the framework of performance-based design approach is presented. The method employs a multi-degree-of-freedom equivalent system instead of the single-degree-of-freedom equivalent system used by the conventional DDBD method. Thus, the proposed method can take more rationally and with higher accuracy into account the higher mode and P-Delta effects than the conventional one. This is accomplished with the aid of the concept of deformation dependent equivalent modal damping ratios previously developed by the present authors for other purposes and the concept of the design modal displacements developed herein. These design modal displacements are determined on the basis of target inter-storey drift ratios for every performance level and the first few modes significantly contributing to the structural response. Thus, one can determine from the displacement spectrum with high amounts of viscous damping the required modal periods for known values of the design modal displacements. From those modal periods, the corresponding required modal stiffness and hence the modal base shear forces can be obtained. The final required design base shear can be obtained by a combination rule, like the SRSS rule. Numerical examples involving the seismic design of two moment resisting reinforced concrete plane frames are presented in detail for illustrating the proposed approach and demonstrating its merits over the conventional DDBD method and the force-based design method of Eurocode 8.