Abstract:Owing to their enhanced mechanical properties and improved structural functions, the use of hybrid CFRP/Ti stacks (a sandwich of one CFRP laminate and one Ti alloy) has experienced an increasing trend in modern aerospace industry. The emergence of such composite-to-metal alliances, however, poses a series of new challenges to the manufacturing sectors for high-quality finishing of the material-made components. The key machining problems usually arise from the disparate natures of the stacked constituents (CFRP laminate and Ti alloy) and their respective poor machinability. To study the fundamental cutting characteristics of the bi-material assembly, this paper presents an experimental study concerning the machinability evaluation of the hybrid CFRP/Ti stacks. An orthogonal cutting configuration (OCC) derived from the real manufacturing operation was adopted to finalize the CFRP/Ti cutting comprehension by using the polycrystalline diamond (PCD) tipped tools. The cutting trials were performed under the reasonable cutting sequence strategy of CFRP → Ti as pointed out by most experimental studies. The key cutting responses including cutting forces, machined surface quality and tool wear mechanisms were precisely addressed versus the utilized cutting conditions. The experimental results highlight that a parametric combination of high cutting speeds and low feed rates often facilitates the reduction of cutting forces and induced damage extents. The basic damage modes promoted on the machined CFRP/Ti surfaces are observed to be fiber pullout, resin loss, surface cavity, deformation of feed marks and re-deposited materials. Moreover, the key wear mechanisms governing the PCD tool cutting are confirmed to be crater wear and flank wear, while the tool failure mode is edge chipping. To ensure the excellent machined surface quality, a stringent control of tool wear should be implemented when cutting hybrid CFRP/Ti stacks.

An Experimental Investigation on Orthogonal Cutting of Hybrid CFRP/Ti Stacks

Experimental Studies on the Cutting Characteristics of Hybrid CFRP/Ti Stacks

Orthogonal Cutting Mechanisms of CFRP/Ti6Al4V Stacks

Wear Characteristics of Polycrystalline Diamond Tools in Orthogonal Cutting of Cfrp/Ti Stacks

Numerical Modeling and FE Analysis of CFRP/Ti Stack Orthogonal Cutting

Processing research on orbital drilling of CFRP/Ti-6Al-4V stacks

Experimental Study on Drilling Mechanisms and Strategies of Hybrid CFRP/Ti Stacks

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

Numerical Modeling of Stacked Composite CFRP/Ti Machining under Different Cutting Sequence Strategies

Numerical study on the chip removal and surface quality of CFRP/Ti6Al4V stacks

A Force Sensorless Method for CFRP/Ti Stack Interface Detection During Robotic Orbital Drilling Operations

Orthogonal Cutting Modeling of Hybrid Cfrp/Ti Toward Specific Cutting Energy and Induced Damage Analyses

Cutting modeling using cohesive zone concept of titanium/CFRP composite stacks

Finite Element Analysis when Orthogonal Cutting of Hybrid Composite CFRP/Ti

On the Interpretation of Drilling CFRP/Ti6Al4V Stacks Using the Orthogonal Cutting Method: Chip Removal Mode and Subsurface Damage Formation

Numerical studies of frictional responses when cutting hybrid CFRP/Ti composite

Numerical Study of Interface Damage Formation Mechanisms in Machining CFRP/Ti6Al4V Stacks under Different Cutting Sequence Strategies

On the Analysis of Temperatures, Surface Morphologies and Tool Wear in Drilling CFRP/Ti6Al4V Stacks under Different Cutting Sequence Strategies

Investigation on the cutting responses of CFRP/Ti stacks: With special emphasis on the effects of drilling sequences

Analysis of high temperature and mixed tool wear effects on UD-CFRP cutting mechanism in stacks drilling

On the Quantitative Analysis of Drill Edge Wear when Machining CFRP/Ti6Al4V Stacks