Surface Roughness and Boundary Load Effect on Nonlinear Flow Behavior of Fluid in Real Rock Fractures

Wu Jiangyu,Yin Qian,Jing Hongwen
DOI: https://doi.org/10.1007/s10064-020-01860-5
IF: 4.2
2020-01-01
Bulletin of Engineering Geology and the Environment
Abstract:This paper experimentally evaluated the influences of the surface roughness and boundary load on the nonlinear flow behavior of real three-dimensional rock fractures. The rough fractures with various joint roughness coefficient (JRC) values in the range of 2.59 to 19.31 were generated with a fractal governing function, and the corresponding fractured granite specimens of a square plate shape in the size of 495 × 495 × 16 mm were manufactured. The fluid flow tests on these fractures were conducted with respect to various hydraulic pressures ranged from 0 to 0.6 MPa and various boundary loads ranged from 7 to 35 kN. The results show that Forchheimer’s law provides an excellent presentation of the relation between the hydraulic gradient and the flow rate, and both the linear and nonlinear fitting coefficients in the Forchheimer’s law show an increasing trend with both increases in the surface roughness and boundary load. The critical hydraulic gradient and critical Reynolds number decrease with the surface roughness. The critical hydraulic gradient increases more significantly under a small boundary load in the range of 7 to 14 kN than that under a high boundary load in the range of 21 to 35 kN. A cubic polynomial function is applied to analyze the transmissivity as a function of the hydraulic gradient, and the transmissivity shows a decreasing trend when the surface roughness and boundary load increase. The flow behavior is assessed by depicting the normalized transmissivity of the fractures based on the hydraulic gradient, and an increase in the surface roughness shifts the fitting curves downwards. The hydraulic aperture shows a hyperbolic decrease as the boundary load increased, and a power-law equation can be used to evaluate the variations in the nonlinear coefficient in terms of the hydraulic aperture.
What problem does this paper attempt to address?