Abstract:High-strength bolted connections have attracted increasing attention over the past few decades because they can safely transfer the design load. However, the effect of the preload loss on the mechanical behavior of the bolted connections has not been investigated sufficiently, This paper presents an experimental investigation of the bearing capacity of high-strength bolted connections with loose bolts (lacking pretension force). The tests investigated ninety specimens with loose bolts and six specimens without loose bolts for comparison. The results showed that bolt fracture was the only failure mode for all of the tested connections under uniaxial tension. The global behavior of the tested connections exhibited four stages, and the features of each stage were summarized. The connections with different tightening conditions exhibited a similar trend in terms of strain development around the bolt holes. The effect of the slip coefficient, position and number of loose bolts, and the plate thickness is elucidated through parametric studies. It is found that the yield load of high-strength bolted connections may be affected by the pretension force and the slip coefficient, while the effect of the slip coefficient gradually decreases with the increasing number of loose bolts. The experimental results are compared to the calculated ultimate bearing resistance according to the GB 50017, Eurocode 3, and AISC 360-16 standards. It is found that the resistance prediction of the standards may be too conservative for the prediction of the ultimate bearing capacity of loose high-strength bolted connections when bolt fracture governs failure. Practical design recommendations in the algebraic form are presented and verified to predict the yield load and ultimate bearing capacity of loose high-strength bolted connections.

Corrosion-Induced Mechanical Degradation of High-Strength Bolted Steel Connection

Ultra-low Cycle Fatigue Properties and Fracture Mechanism of Corroded Structural Steel

Test on shear behavior of less-tightened high-strength bolted connections

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Corrosion-induced mechanical properties of shear bolted connections in high-strength weathering steel

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

Experimental study on slip performance of corroded bolted connections

Experimental investigation of mechanical behavior of grade 8.8 and 10.9 small-sized (m14-m20) bolts with the thread into the bolt hole

Experimental Investigation of Corroded Stud Shear Connectors Subjected to Fatigue Loading

Corrosion effects on the fatigue performance of high-strength bolted friction connections

Experimental Investigation and Design of Corroded Stud Shear Connectors

Experimental study on the corrosion performance of weathering high-strength bolt connections

Shear performance of high-strength bolted connections with stainless-clad steel plates in a corrosive environment

Behaviour Of Corroded Single Stud Shear Connectors

Behaviour of Corroded Stud Shear Connectors under Fatigue Loading

Mechanical Performance of Artificially Rusted Q500MC Structural Steel Subjected to High Temperature

Static and Fatigue Behavior of Steel-Concrete Composite Beams with Corroded Studs

Degradation and failure analysis of bolted joints under transverse loading

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

High-Temperature Mechanical Properties of Artificially Simulated Corroded Q500MC Structural Steel

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams