Abstract:The two-phase heat transfer of saturated liquid nitrogen (LN2) flow boiling in a horizontal corrugated tube was experimentally studied. The experiments were conducted at different inlet pressures of 0.180-0.461 MPa and mass fluxes of 163.1-257.1 kg m(-2) s(-1) under a wide range of heat flux of 16,000-40,000 W m(-2). The flow pattern was identified to be unstratified flow according to the circumferential distributions of heat transfer temperature differences. Two heat transfer regimes were observed in the present experiment: the nucleate boiling dominated heat transfer and the convective evaporation dominated heat transfer. Due to the thinning of the liquid film at the tube inner surface caused by helical fin, nucleation suppression and convection augmentation were observed and the variation of the circumferential average HTC with the flow parameters became complex depending on the relative importance of the two heat transfer mechanisms. The effects of heat flux, vapor quality, inlet pressure and mass flux on the circumferential average heat transfer coefficient (HTC) are discussed. The results show that the nucleate boiling heat transfer is enhanced with the increase of heat flux, while the convective evaporation is enhanced with the increase of mass flux and vapor quality, and the decrease of pressure. In order to improve the prediction of HTCs, the Klimenko correlation for cryogenic fluids are included in an additive model. Based on the experimental data of circumferential average heat transfer coefficients, the parameterization of the additive model including the convective and nucleate boiling components was obtained for the LN2 saturated flow boiling in the corrugated tube. Compared to the Klimenko correlation for the flow boiling of cryogenic fluids with a fully wetted perimeter in smooth tubes, the proposed parameterization of the additive model improves the prediction of HTCs in the convective evaporation dominated regime. (C) 2016 Elsevier Inc. All rights reserved.

Film boiling heat transfer prediction of liquid nitrogen from different geometry heaters

Experiment for influence of boiling surface on critical heat flux in liquid nitrogen pool boiling

Observation and Analysis of the Detachment Frequency of Coalesced Bubbles in Pool Boiling Liquid Nitrogen

CFD Simulations and Experimental Verification on Nucleate Pool Boiling of Liquid Nitrogen

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

Heat transfer prediction on film boiling of liquid hydrogen under normal gravity and microgravity environments

BOILING HEAT TRANSFER OF LIQUID NITROGEN AROUND A HEATING WIRE

Study on Film Boiling Heat Transfer for Water Jet Impinging on High Temperature Flat Plate

CFD Study on Film Boiling Features of Cryogenic Fluid Influenced by Heat Structures and Gravity Levels

Review of liquid nitrogen flow boiling heat transfer

FLOW BOILING OF LIQUID NITROGEN IN MICRO-TUBE——TWO-PHASE HEAT TRANSFER ANALYSIS

Numerical Study on Pool Film Boiling of Liquid Hydrogen over Horizontal Cylinders

Subcooled Boiling Heat Transfer Characteristics and Correlation Development for Narrow Rectangular Channels with a Large Aspect Ratio under High-Pressure Conditions

Direct Numerical Simulations of Film Boiling Heat Transfer by a Phase-Change Lattice Boltzmann Method

Experimental Study on Heat Transfer Characteristics of LN2 Saturated Flow Boiling in a Horizontal Corrugated Tube

Experimental Design and Analysis for Film Boiling Heat Transfer in a Circular Tube

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

Saturated/subcooled Flow Boiling Heat Transfer Inside Micro/mini-Channels: A New Prediction Correlation and Experiment Evaluation

A Comprehensive Numerical Study on the Subcooled Falling Film Heat Transfer on a Horizontal Smooth Tube

Heat transfer correlation of smooth inverted annular film boiling in a circular tube

Assessment of two-phase heat transfer coefficient and critical heat flux correlations for cryogenic flow boiling in pipe heating experiments