Abstract:Up to now, the installation capacity in China is more than 440,000MW. It stimulates cable manufacturing industry and operating system. In 2004, increasing power lines of 330kV and higher was 11,421km, including 1,857km DC, and in 2005, the power line of 220kV and higher is 25,000km. Transforming capacity is about 140,000MVA. It predicates that Chinese power wire and cable industry has entered into a period of rapid progress. XLPE cable become a main part of power cables not only in middle and low voltage systems, but in high voltage ones of 220kV and higher. 500kV XLPE cable was produced in the year of 2004, and large-length submarine XLPE cable was produced and served in the power system in 2002. Comparing with those, high-voltage cable accessories have not been produced as a complete set, even though new materials and configuration for the accessories are under research. The HTS cable of 35kV has been manufactured and passed through the certification test in 2004. There are two independent power grid management systems. Cable construction and operation system also change remarkably. There are mainly 3 systems of underground cable layings in China, i.e. the pipeline, trench and tunnel. Considering the cost and time limit for a project, pipeline laying is a better method. It has been widely used during the process of power cables to be laid underground in cities of China, and it is also the tendency in the future. The cable insulation on the bridge and under the water has new requirement not only for construction and properties of the cables, but also on installation technology. Large-length cables on the bridge and under the water has been installed and operated successfully. All of these improved the technology progress on Chinese cable manufacturing and operating. Technical failures and accidents also occurred during the cable operation, which show that there are deficiencies in the progress of Chinese cable technology, including cable breakdown due to the insulation quality, water immersion, especially in the joints. Fire-proof technology is very important to cable system as well. Biological infestation for cables should be paid attention also, for example, termite and rat. All of these are introduced in this paper in detail.

Development of a Voltage Resistance Device for Low Voltage Cables

Development of High - Voltage Pulse - Transmission Electric Cable for Plasma Drill

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Distributed Partial Discharge Detection Technology for High Voltage Cable Based on Ac Withstand Voltage

Development of a Novel 20 Kv 0.1 Hz Very Low Frequency Cosine-Rectangular Voltage Generator for Multi-Functional Insulation Testing of MV Power Cables

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

Development of High Voltage Direct Current Extruded Cables

Insulation State Detection Method for DC XLPE Cable

Development of cable products and systems in China in recent years

Faults Analysis of DC Feeder Cable and Countermeasures

On-site Insulation Tests for MV Cable Using Very Low Frequency and Damped AC Techniques

Study about Insulating Properties of 10 Kv XLPE Damp Cable

Distribution Characteristics of Insulation Interfacial Defects in High Voltage Direct Current Cables

The Application Research of Very Low Frequency Diagnostic Methods in Acceptance Tests on New Cable Systems of Medium Voltage

Failure Analysis of HVDC Cable Accessories During R&D Tests

Influence of Cross-linking Characteristics of DC Cable Insulation on DC Performance

Research on the Insulation Properties of 10kv Xlpe Damp Cable

Detection of Insulating Performance for Unarmored Cable under DC Leakage Current

Study on the Electric Field Distortion Caused by Interface Defects in the XLPE Insulation of One 20 Hz Cable

Review and Expectation of Diagnosis Technology on Insulation of DC Cable of Urban Transit

Analysis of DC Cable Fault in Shanghai Metro