Abstract:To improve the structural performance of precast assembled concrete piers under earthquake, we designed and manufactured two piers confined by carbon fiber reinforced polymer (CFRP) sheets (SPCC1, SPCC2), two piers confined by glass fiber reinforced polymer (GFRP) tubes (SPCG6, SPCG10), and one comparison pier (SPC). The column and bent cap connections were designed with a monolithic construction, whereas the column and pile cap connections had precast joints with grouted sleeves. The effects of the CFRP and GFRP on the seismic performance of the specimens were studied using a quasi-static test and a fiber model based on OpenSees. The failure modes of the specimens included concrete crushing in the plastic hinge zone and buckling fracture of the longitudinal reinforcement. A CFRP tensile fracture occurred in the plastic hinge zone at the top and bottom of the piers; however, damage to the GFRP tubes was minor. Compared with sample SPC, the maximum bearing capacities of SPCG6, SPCG10, SPCC1, and SPCC2 increased by 8.4%, 3.1%, 15.0%, and 4.8%, respectively. At 7% displacement, the residual bearing capacities of SPCG6, SPCG10, SPCC1, and SPCC2 increased by 103.3%, 90.4%, 36.7%, and 82.8%, respectively, compared with SPC. At 6% and 7% displacement, the average stiffness of the CFRP/GFRP-confined specimens increased by 46.2%/58.9% and 59.8%/96.8%, respectively, compared with that of the unconfined specimen. The curvature results also showed that the confined pier exhibited a better flexural performance in most loading processes. The test and simulation results showed that the connection strength of the grouted sleeve in the precast structure should be ensured, and the reinforcement ratio of the pier should be prioritized, followed by an appropriate improvement in the compressive strength of the concrete. The constraint range of the FRP at twice the height of the plastic hinge zone was sufficiently conservative to ensure that the pier maintained good seismic performance under a high axial compression ratio. In practical engineering, the use of a GFRP tube as a template for a prefabricated pier is recommended, and a CFRP sheet is used to strengthen the plastic hinge area of an existing pier with insufficient seismic ability.

Experimental Study on the Seismic Performance of PUFA Confined RC Bridge Pier

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Preparation of polyurethane concrete and its novel application in bridge expansion joint anchorage zone

Experimental Study on the Seismic Behaviour of Reinforced Concrete Bridge Piers Strengthened by BFRP Sheets

Quasi-static tests and seismic fragility analysis of RC bridge piers with high-strength steel bars and high-strength/ultra-high performance concrete

Seismic Behavior of RC Bridge Piers Locally Replaced with SFRC-FA Subjected to Torsion Combined with Axial Compression

Study on Shear Bond Behavior of PUFA-to-Concrete Interface

Study on static load test of simply supported hollow slab bridge flexural strengthened with polyurethane–cement composite

An experimental study on strengthening reinforced concrete T-beams using new material poly-urethane-cement (PUC)

Fatigue performance of a simply-supported T-beam UHPC bridge deck variable section joint structure

Experimental and numerical study of precast bridge piers with a new UHPC socket column-footing connection

Strengthening of a Reinforced Concrete Bridge with Polyurethane-cement Composite (PUC)

Experimental Investigation of Axial Behavior of Strengthened Reinforced Concrete Columns Using Polyurethane-Cement(PUC)

Lateral Cyclic Response Sensitivity of Rectangular Bridge Piers Confined with UHPFRC Tube Using Fractional Factorial Design

Study on Seismic Performance Optimization of Assembly Concrete-Filled Steel Tubular (CFST)-Laced Piers

Seismic Performance of FRP-Confined Precast Assembled Concrete Piers: An Experimental Study

STUDY ON REINFORCEMENT OF FABRICATED HOLLOW SLAB BRIDGE BY POLYURETHANE-CEMENT COMPOSITE (PUC)

Experimental Research on Mechanical Properties of Fiber-Reinforced Polyurethane Elastic Concrete (FRPEC)

Numerical Simulation Analysis on Shear Bond Behavior of PUFA-to-Concrete Interface

Cyclic loading test for RC bridge piers strengthened with UHPC jackets in the corrosive environment