Abstract:In this paper, the design and experimental verification of the rotor system with gas foil bearings are carried out with a vehicle compressor developed in our laboratory. The designed rotating speed 100,000 rpm with 50 g/s mass flow and 1.8 pressure ratio. The journal foil bearing with inhomogeneous bump foil is designed and tested by a push-pull device to evaluate the structure stiffness of bump foil. The result shows that the stiffness curves of two bearings with the same manufacturing process are not consistent, which indicates the uncertainly in the manufacture of foil bearings and it is necessary to obtain the foil stiffness data by experiment. A multi-disc model is established to simulate the impeller in the finite element model (FEM) for the vehicle compressor is too short to ignore the impeller width. The stiffness and damping coefficients of foil bearings are used to proceed rotordynamic analysis. The vibration experiments indicate that with the operating speed enhancement, the center orbit falls smaller. When the rotating speed increases to about 60,000 rpm, two sub-synchronous frequency occur and remain at 150 and 307 Hz finally. Two radial acceleration peaks appear at 9736 and 25,828 rpm respectively, which are close to the critical speed of damped Campbell diagram. The compressor performance map shows that the pressure ratio of the compressor is slightly lower than the design value due to the eccentricity of the foil bearing, which can be solved by increasing the operating speed. This paper provides some reference value for the design and experiment of vehicle compressor supported by the foil bearings.

The Vibration Characters Analysis of Tube Compressor

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Dynamic analyses for the rotor-journal bearing system of a variable speed rotary compressor

Modal Analysis of the Rotor-Journal Bearing System of Rotary Compressor

Dynamic Analysis of High Speed Turbine Rotor with Foil Bearing

Vibration and Stability Analysis of a Multi-stepped Shaft System of Turbo Compressor

The Force Analysis and Study of the Critical Speed for Sliding Vane of Translational Rotary Compressor

Analyse Rotor Dynamics of Agitating Shaft with the Finite Element Method

Modal and vibration analysis of reciprocating compressor crankshaft system

Nonlinear Vibration Analysis of a Low-Pressure Rotor-Bearing System for 200MW Steam Turbine

Numerical investigation on the rotordynamics of a high-speed air compressor supported by gas foil bearings

Dynamic characteristics analysis of a dual-rotor system with inter-shaft bearing

Research on the Effect of Bearing Parameter Change on the Natural Characteristic of Large Centrifugal Compressor based on Finite Element

The Influence of Ring-Speed Ratio Dynamic Change on Nonlinear Vibration Response of High-Speed Turbocharger Rotor System

Investigation On Coupled Torsional-Lateral Vibrations In A Geared Rotor-Hydrodynamic Bearing System - Part 2: Dynamical Analytical Model

Analysis of Transient Vibration of Single-Thick-disk Rotor Crossing Two Orders of Critical Speeds

Transient Analysis of A Rotor-Journal Bearing System under Large and Dynamic Loads

The Crankshaft Vibration Analysis of Large-type Piston Compressor-Modal Analysis

Coupled Bending and Torsional Vibrations of Geared Rotor System

Design and Experimental Verification of the Vehicle Compressor Rotor System with Inhomogeneous Foil Bearings

Investigation On Coupled Torsional-Lateral Vibrations In A Geared Rotor Hydrodynamic Bearing System - Part 1: Analytical Model