Abstract:The liner is a wear-prone component in ball mills, subject to continuous impacts, squeezing, and abrasion from the grinding media during operation. Its service performance directly affects the working efficiency of the ball mill. The service life of mining ball mill liners is about 8 months, and frequent downtimes occur due to liner wear and loss of effectiveness, with liner replacement accounting for about 6% of the total cost, resulting in huge economic losses. This paper focuses on a Φ305 mm × 150 mm experimental ball mill, using the discrete element software Rocky Discrete Element Method (DEM) (software version number Rocky 2022 R2) for simulation modeling analysis. With Φ10 mm and Φ20 mm mono-size particle simulations serving as reference groups, this study investigates the motion states and liner abrasion patterns under different liner heights for both sizes of grinding media in Equilibrium Quality Manufacturer (EQM) and Original Equipment Manufacturer (OEM) gradations. The results indicate that the impact of liner height on the wear of the ball mill liners is related to the size and gradation of the grinding media. The degree of liner wear from highest to lowest is as follows: EQM > Φ20 mm > OEM > Φ10 mm. Due to the effect of the cylinder end cap, the wear at the axial center of the ball mill liner is more severe than at both ends, and the wear on the facing side of the liner is more severe than on the backside. A thorough study of the influence of ball mill grinding media gradation on the wear pattern of liners is of great theoretical significance for optimizing liner structures, improving grinding efficiency, and promoting energy saving and cost reduction in ball mills. This study provides theoretical guidance for understanding the mechanisms behind liner wear in ball mills and predicting the liner lifespan.

Influence of lifter height on the grinding efficiency of ball mill

Effect of the operating parameter and grinding media on the wear properties of lifter in ball mills

Impact Load Behavior between Different Charge and Lifter in a Laboratory-Scale Mill

Effect of Lifter Shapes on the Mill Power in a Ball Mill

Investigating the Influence of Medium Size and Ratio on Grinding Characteristics

Experimental Study and Numerical Simulation of the Influence of Ball Milling on Mechanical and Physical Properties of Matcha Powder

Effect of grinding media on the milling efficiency of a ball mill

Influence of ball size distribution on grinding effect in horizontal planetary ball mill

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Effects of Ball Size Distribution and Mill Speed and Their Interactions on Ball Milling Using DEM

Effect of Grinding Media Grading on Liner Wear and Load Behavior in a Ball Mill by Using Rocky DEM

An innovative approach for determining the grinding media system of ball mill based on grinding kinetics and linear superposition principle

Investigation of the Effect of Filling Level on the Wear and Vibration of a SAG Mill by DEM

DEM Investigation of Discrete Heat Transfer Behavior of the Grinding Media in Ball Mills

Dem Investigation Of Sag Mill With Spherical Grinding Media And Non-Spherical Ore Based On Polyhedron-Sphere Contact Model

Numerical Prediction of Wear in SAG Mills Based on DEM Simulations

Influence of Steel Ball Ratio on Operation Performance of a Ball Mill Pulverizing System

Research on An Accurate Simulation Modeling and Charge Motion Quantitative Evaluation Method for Ball Mill in Confined Space

Effect of ball size and powder loading on the milling efficiency of a laboratory-scale wet ball mill

Study on Energy Transfer Mechanism of Grinding Balls in a Planetary Ball Milling System

Numerical Investigation of a Vertical Roller Mill Using DEM-MBD Coupling Method