Abstract:Effects of addition of cationic high molecular weight polymers (CP) as a primary flocculant or coagulant aid,,on the treatment efficiencies for raw water with low temperature (T10℃) and low turbidity (C010 NTU) were measured. The raw water was obtained from the Qujiang water treatment plant in Xi′an, China and investigated using a micro-flocculation depth-bed direct filtration process. Fractal mathematics and image analysis were used to analyze the effects of the following factors on treatment efficiencies: filter medium; raw water turbidity and temperature; chemical type, molecular weight and dosage of polymer; and mixing strength. The flocculation mechanism, floc morphologies and the fractal properties of floc structures were also compared after adding different flocculants. Five important results were obtained: ① It is not suitable to use Al2(SO4)3 (AS) or polyaluminium chloride (PAC) alone when T4℃, C04 NTU. Fine sand filter medium should be used if Al2(SO4)3 or PAC is added alone under the conditions 4℃T10℃, C010 NTU. For raw water with low temperature and turbidity, the flocs formed from inorganic coagulants are small, loose and fragile structures, with low efficient mass density and settling rate, but high fractal dimension. ②A coarse sand filter markedly improved CP flocculation efficiencies of raw water with low temperature and turbidity; but the mixing strength should be increased due to high viscosity of CP; ③It is appropriate to use low molecular weight polymers with weakly cationic properties or a lower dosage of CP with strong cationic properties if CP serves as a primary flocculant. When CP is used as a coagulant aid, the dosage of the primary coagulant can be greatly decreased, but it is better to use high molecular weight polymers with strong cationic properties or to increase the dosage of CP with weak cationic properties. ④The flocculation mechanisms of CP are charge neutralization, adsorption and bridging. Flocs formed from CP have have large network configurations, which lead to reduced sludge volumes and increased sludge settling rates as well as good dewatering behavior, but have a lower fractal dimension than inorganic flocs. ⑤ The treatment efficiencies of all tested flocculants are as follows: Al2(SO4)3 (or PAC) +CP CPPAC Al2(SO4)3 .

Combination coagulation using multiple coagulants for low turbidity water treatment

A Comparative Study Of Conventional Coagulation And Sludge Recycling Enhanced Coagulation For Low-Turbidity Source Water: The Effect And Applicability

Coagulation performance and mechanism of polyaluminum ferric chloride (PAFC) coagulant synthesized using blast furnace dust

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Multiple Response Optimization of the Coagulation Process for Upgrading the Quality of Effluent from Municipal Wastewater Treatment Plant

Landfill Leachate Pretreatment by Coagulation–flocculation Process Using Iron-Based Coagulants: Optimization by Response Surface Methodology

Coagulation efficiency and removal mechanism for composite coagulant polyaluminium chloride/polydimethyldiallylammonium chloride in treating lightly micro-polluted raw water of Yangtze River in autumn

An enhanced coagulation using ferric chloride and poly-ferric chloride coagulant assisted by polyamidine: Performance and mechanisms

Coagulation performance of Al/Fe based covalently bonded composite coagulants for algae removal

Enhanced Coagulation for High Alkalinity and Micro-Polluted Water: the Third Way Through Coagulant Optimization.

Enhanced Coagulation of Low-Turbidity Micro-Polluted Surface Water: Properties and Optimization.

Application of a green coagulant with PACl in efficient purification of turbid water and its mechanism study

Flocculation Performance of PCFA Composite Coagulant for Removing Nanoparticles

The performance of enhanced coagulation for treating slightly polluted raw water combining polyaluminum chloride with variable charge soil

Facile synthesis of composite polyferric magnesium–silicate–sulfate coagulant with enhanced performance in water and wastewater

Efficient removal of per- and polyfluoroalkyl substances (PFASs) from stored rainwater by composite metal salt /polydimethyldiallylammonium chloride coagulants

Modeling and optimization of the coagulation/flocculation process in turbidity removal from water using poly aluminum chloride and rice starch as a natural coagulant aid

Optimization of the Coagulation-Flocculation Process for Pulp Mill Wastewater Treatment Using a Combination of Uniform Design and Response Surface Methodology

Flocculation Efficiencies and Morphological Properties of Cationic Polymers in the Treatment of Low Temperature and Low Turbidity Raw Water

A membrane fouling control strategy based on a combination of pre-treatment mitigation and in-situ membrane surface regulation using a composite coagulant

Efficient Removal of Phosphorus from Turbid Water Using Chemical Sedimentation by FeCl3 in Conjunction with a Starch-Based Flocculant