Strengthen of coagulation for light pollution water with low turbidity by recycling of backwash water from filter
Si XIE,Yanling YANG,Xing LI,Zhiwei ZHOU,Zhaoyang SU,Bo LI,Ling LIU
DOI: https://doi.org/10.3969/j.issn.0438-1157.2013.05.043
2013-01-01
Abstract:This study focuses on distribution of light pollution water with low turbidity, by adjusting dosage of polyaluminum chloride(PACI) to control floc zeta potential. Influence of backwash water(FBWW)with different coagulation characteristics from filter on coagulation efficiency was also investigated. The results show that FBWW is of good efficiency on turbidity removal as zeta potential close to -11 mV. The maximum removal rate for settled water was 63.81%, and it was higher than that at other potentials by using this processing. And the lowest residual AlP content was found about 0.271 mg·L-1 at this potential. However, excessive backflow(12%)can lead to additional consumption of PACl in this stage, which makes particle matter in raw water to obtain sufficient coagulant difficult and the system to lose stabilization, and so, turbidity, CODMn, AlP, AlD, etc. goes up. When zeta potential is close to 0 mV, the FBWW is also of good effect on CODMn, UV254 and AlP, and AlD can stay in a relative low value as well. If reflux ratio is 9%, the removal rate of CODMn can reach the highest test value, about 34.21%. When zeta potential is placed at close to +4 mV, the reflux of FBWW can cause substantial increase of turbidity, CODMn, AlP and AlD, while removal efficiency for UV245 is improved. This trend was most obvious for the backflow ratio about 12%, at which the highest test value of UV254(60.67%)is obtained. By comparing residual organic matters in filtered and settled water, a significant difference between these organic matters is found. The removal rates of UV254 and CODMn were higher for the filtered water at +4 mV. © All Rights Reserved.