Abstract:Using a high-temperature flow calorimeter, we determined the molar heat capacities at constant pressureCp, mof four binary mixtures at three different temperatures (410.3, 514.7, and 630.6) K and various compositions. The binaries investigated are: (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (acetone+trichloromethane). AtT630.6 K, all these mixtures showed ideal gas behavior,i.e.heat capacity additivity. However, excess heat capacities were found at lower temperatures, particularly in (Lewis base+acidic proton) and (non-polar+polar) binary systems, such as (acetone+trichloromethane), (benzene+acetone), and (benzene+trichloromethane), but no significant excess heat capacities were detected in (non-polar+non-polar) systems. The excess heat capacity can be attributed to intermolecular interaction between unlike molecules. The heat capacities of the binary mixtures considered in the experiment were also calculated using both cubic (van der Waals)-type and virial-type equations of state: PR EOS and truncated virial EOS, respectively. The two EOSs gave comparable results. However, there are some statistically significant biases between the calculated results and experimental values in systems containing a polar component. This may be due to the limitations of the mixing rules used in the calculation.

Thermodynamic Studies of 4-pyridinemethanol

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Measurement of Vapor Liquid Equilibrium for System of Ethyl Acetate-Pyridine at Different Pressures

Excess Molar Enthalpies of Methylformate+(1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol and 1-Pentanol) at T=298.15K, P=(5.0, 10.0)mpa, and Methylformate+1-Propanol at T=333.15K, P=10.0mpa

Excess Molar Enthalpies of Ethylformate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5 and 10) Mpa

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Experimental Study of Pvtx Properties in the Gas Phase for Binary Mixtures of Dme and Hfc-134a

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

Low-Temperature Heat Capacity and Thermodynamic Properties of Crystalline 2-Chloro-5-trichloromethylpyridine

Thermodynamic Properties of 3- and 4-Ethoxyacetanilides between 80 and 480 K

Excess Molar Enthalpies of Dimethyl Carbonate and (methanol, Ethanol, 1-Propanol, and 2-Propanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Molar excess enthalpies of ethyl acetate+alkanols at T=298.15K, p=10.0MPa

Low-temperature heat capacities and phase transitions of the ternary system of (0.195 ethandiol + 0.132 ethanol + 0.673 water)

Study on Stability and Molar Heat Capacity at Constant Pressure of Polyhydroxylated Dibenzofurans

Heat capacities and thermal conductivity of ternary mixtures of water+ethanol+1,2-ethanediol between 75 and 350 K

Determination of Vapor Pressure, Enthalpy of Vaporization, and Heat Capacity of Methyl 4- tert -Butylbenzoate

The Molar Heat Capacities of (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (Acetone+trichloromethane)