Studies on the Induction of Poly(lactic acid) Stereocomplex by Thermal and Tensile Treating

Gang Wang,Ke Wang

DOI: https://doi.org/10.11777/j.issn1000-3304.2018.18011

2018-01-01

Acta Polymerica Sinica

Abstract:Adding stereocomplex (SC) crystals into matrix can effectively improve the hydrolysis resistance and heat-resistance of polylactic acid (PLA). However, the existence of pre-formed SC crystals will increase the processing difficulty because a higher processing temperature is needed. Thus the exploration of inducing SC crystals via external force fields is important. In this paper, 'quenched' and 'annealed' PLA enantiomer mixtures were studied. The enantiomer mixtures were prepared by solution coprecipitation. Preparation of the 'quenched' specimen is done in two steps: hot pressed at 250 degrees C for 5 min and then quenched in air (15 degrees C). The method of annealing is done as following: hot pressed at 250 degrees C for 5 min, annealed at 200 degrees C for 30 min, and finally quenched in air. The X-ray diffraction patterns indicated that a loose structure with low order degree, named as quasi-ordered phase (QOP), was formed in the two types of the samples. Based on this structure, SC crystals was formed during stretching near the glass transition temperature (T-g) of PLA. The results of infrared spectra indicated that adequate amount of poly(D-lactic acid) (PDLA) is the prerequisite for the induction of SC crystals. There was no SC crystal generated in the specimens with 5% of PDLA, regardless of the treatment used. However, SC crystal appearred in the specimens with 20% of PDLA. This is because that adequate amount of QOP regions can merge and rebuild into complete crystals. In the specimens of high PDLA content, the transition could happen either during annealing or stretching above Tg (e.g., 70 degrees C). Owing to the self-nucleation and heterogeneous nucleation of QOP, alpha'-form crystal would be formed concomitantly during annealling. Therefore the former approach cannot generate pure SC crystal. As to the latter approach, depending on the tensile temperature and rate, mesophase, SC crystal and alpha'-form can be selectively generated. When stretched below Tg (e.g., 50 degrees C), only mesophase can be obtained beacause of low chain activity. As stretched at 70 degrees C, the tensile model has a great effect on the induced results. Fast stretching will induce highly pure SC crystals. Otherwise, when given sufficent time for chain segmet adjustment, both SC and alpha'-form crystals would be induced.