Abstract:The lamellae deformation and cavitation behavior of annealed isotactic polypropylene during uniaxial stretching are comprehensively investigated by in situ synchrotron small-angle X-ray scattering and wide-angle X-ray scattering. We reveal how lamellae deformation occurs in the time scales of elastic deformation, intralamellar slip, and melting-recrystallization, separated by three critical strains which are only rarely influenced by annealing. Strain I (0.1) marks the end of elastic deformation and the onset of intralamellar slip, beyond which the crystallinity decreases gradually. Strain II (0.45) signifies the start of the recrystallization process, from where the long period in the stretching direction begins to decrease from its maximum and the polymer chains in the crystal start to orient along the stretching direction. The energy required for melting arises from the friction between the fragmented lamellae produced by intralamellar slip. Strain III (0.95) denotes the end of the recrystallization process. Beyond the strain of 0.95, the long period and the crystal size remain nearly unchanged. During further stretching, the newly formed lamellae serve as the anchoring points for polymer chains in the amorphous phase. The extension of the polymer chains in between lamellae triggers the strain hardening behavior. On the other hand, annealing significantly decreases the critical strain for voids formation and increases the voids number but restricts the void size. For those samples annealed at a temperature lower than 90 degrees C, voids are formed between strain II and strain III, and voids are oriented in the stretching direction once they are formed. However, for those samples annealed at a temperature higher than 105 degrees C, voids are formed between strain I and strain II. In this case, voids are initially oriented with their longitudinal axis perpendicular to the stretching direction and then transferred along stretching direction via void coalescence. Additionally, the formation of voids influences neither the critical strains for lamellae deformation nor the final long period, the orientation of polymer chains, or the crystal size. The final long period, the orientation of polymer chains in the crystal, and the crystal size are determined only by the stretching temperature through melting-recrystallization.

Direct Investigations on Strain-Induced Cold Crystallization Behavior and Structure Evolutions in Amorphous Poly(lactic Acid) with SAXS and WAXS Measurements

Thermal Strain-Induced Cold Crystallization of Amorphous Poly(lactic Acid)

Deformation and structure evolution of glassy poly(lactic acid) below the glass transition temperature

Critical Strains for Lamellae Deformation and Cavitation During Uniaxial Stretching of Annealed Isotactic Polypropylene

Structure Evolution of Polyethylene-Plasticizer Film at Industrially Relevant Conditions Studied by In-Situ X-ray Scattering: the Role of Crystal Stress

Studies on the Induction of Poly(lactic acid) Stereocomplex by Thermal and Tensile Treating

Influence of stretching on crystallization behavior of poly(L-lactic acid)

Annealing-induced oriented crystallization and its influence on the mechanical responses in the melt-spun monofilament of poly(L-lactide)

Constrained and Free Uniaxial Stretching Induced Crystallization of Polyethylene Film: A Comparative Study

Multiscale Structural Evolutions and Deformation Mechanisms of Stereocomplexed and Homocrystalline Poly(lactic acid)s during Stretching: Correlating Thermomechanical Properties with Polymorphic Structures

Motion Mode of Poly(lactic Acid) Chains in Film During Strain‐induced Crystallization

Structure evolution of amorphous poly(d-lactic acid) on highly oriented poly(l-lactic acid) film during annealing

Extensional Stress-Induced Orientation and Crystallization Can Regulate the Balance of Toughness and Stiffness of Polylactide Films: Interplay of Oriented Amorphous Chains and Crystallites

Structural Characteristics of Fibrillar Crystals in Uniaxially Stretched Isotactic Polypropylene Dominated by Temperature and Strain

Effect of Nucleating Agent on Strain-Induced Crystallization of Films

Crystal Structure and Morphology Influenced by Shear Effect of Poly(L-Lactide) and Its Melting Behavior Revealed by Waxd, Dsc and In-Situ Pom

Conformation Directed Mpemba Effect on Polylactide Crystallization

Glassy Structure Affected Cold-Crystallization Behavior and Structure of Poly(lactic Acid)

Structural Evolution of LLDPE-LMW/HMW Blend During Uniaxial Deformation As Revealed by in Situ Synchrotron Radiation X-ray Scattering

Effect of poly(lactic acid) crystallization on its mechanical and heat resistance performances

Melt extension-induced shish-kebabs with heterogeneous spatial distribution of crystalline polymorphs in lightly crosslinked poly(lactic acid)