Abstract:Using calculations from first principles based on density functional theory we have studied the strain sensitivity of the high-field superconducting magnet A15 Nb3Sn. The Nb3Sn lattice cell was deformed in the same way as observed experimentally on multi-filamentary, technological wires subject to loads applied along their axes. The phonon dispersion curves and electronic band structures along different high-symmetry directions in the Brillouin zone were calculated, at different levels of applied strain, {\epsilon}, both on the compressive and the tensile side. Starting from the calculated averaged phonon frequencies and electron-phonon coupling, the superconducting characteristic critical temperature of the material, Tc, has been calculated by means of the Allen-Dynes modification of the McMillan formula. As a result, the characteristic bell-shaped Tc vs. {\epsilon} curve, with a maximum at zero intrinsic strain, and with a slight asymmetry between the tensile and compressive sides, has been obtained. These first-principle calculations thus show that the strain sensitivity of Nb3Sn has a microscopic and intrinsic origin, originating from shifts in the Nb3Sn critical surface. In addition, our computations show that variations of superconducting properties of this compound are correlated to stress-induced changes in both the phononic and electronic properties. Finally, the strain function describing the strain sensitivity of Nb3Sn has been extracted from the computed Tc({\epsilon}) curve, and compared to experimental data from multi-filamentary wires. Both curves show the expected bell-shaped behavior, but the strain sensitivity of the wire is enhanced with respect to the theoretical predictions of the bulk, perfectly binary and stoichiometric Nb3Sn. Understanding the origin of this difference might open potential pathways towards the improvement of the strain tolerance in such systems.

Simulation of Transport Properties in Nb3Sn Strand under Bending

Modified Beam Theories for Bending Properties of Nanowires Considering Surface/Intrinsic Effects and Axial Extension Effect

In Situ Observation of High Bending Strain Recoverability in Au Nanowires

Residual Stress in Nb3Sn Superconductor Strand Introduced by Structure and Stoichiometric Distribution after Heat Treatment

Micromechanical modelling on the elastoplastic damage and irreversible critical current degradation of the twisted multi-filamentary Nb3Sn superconducting strand

Initial damage influence of stiffness reduction for bronze route Nb3Sn strands

Comparative Study on the Strain-Dependent Mechanical and Electronic Properties of Nb3Al and Nb3Sn

Deformation and Bifurcation Analysis of Boron-Nitride Nanotubes

A Three-Dimensional Strain Model for the Superconducting Properties of Strained International Thermonuclear Experimental Reactor Nb3sn Strands

Atomic Simulation of the Bending Deformation of A Single-Crystal Simply Supported Nano-Beam

Multi-contact behaviors among Nb3Sn strands associated with load cycles in a CS1 cable cross section

Direct measurement of inter-filament resistance in Nb3Sn multi-filamentary strands

Continuum Modeling of Boron Nitride Nanotubes

Experimental simulation of bending damage of silicon nitride yarn during 3D orthogonal fabric forming process

A Simple Phenomenological Model for Characterizing the Coupled Effect of Strain States and Temperature on the Normal-State Electrical Resistivity in Nb3Sn Superconductors

Numerical Simulation of the Mechanical Properties of the $\hbox{nb}_{3}\hbox{sn}$ CICCs under Transverse Cyclic Loads

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

Theoretical and numerical investigation of bending properties of Cu nanowires

Strain sensitivity and superconducting properties of Nb3Sn from first principles calculations

Strain Distribution and Critical Current Characteristics of an Individual REBCO Tape and Quasi-Isotropic Superconducting Strand Under Bending Loads by the Layerwise Theory

Electromechanical coupling in high-pressured superconducting Nb3Sn: analytical and simulation models