Abstract:The oxidation of bond coat (BC) and interdiffusion between BC layer and superalloys were two mechanisms that contribute to the degradation of thermal barrier coating system (TBCs). The oxidation and interdiffusion of TBCs on single-crystal superalloys were comparatively studied in this work at 950 °C, 1050 °C and 1100 °C over a duration of 1500 h. The results indicated that the thickness of the thermally grown oxide (TGO) progressively increased with the oxidation time and temperature, following a parabolic law. The discontinuous TGO gradually developed into a double-layer structure: the upper layer was a mixed oxide layer, while the lower layer predominantly comprises an Al 2 O 3 layer. Moreover, an interdiffusion zone (IDZ) is formed at the interface between the BC layer and the substrate, with its thickness increasing in response to both temperature and oxidation time. The Cr-rich phases appeared in the IDZ, where Al initially diffused from the BC layer to the substrate, followed by a reverse diffusion process. Simultaneously, Ni and refractory elements diffused from the substrate into IDZ, resulting in the precipitation of the topologically close-packed (TCP) phases and the formation of a secondary reaction zone (SRZ). It has further been shown that Cr-rich phases further diffused into SRZ. Higher oxidation temperatures accelerated the growth of the SRZ and facilitated the transformation of the TCP phases from a blocky to a needle-like morphology. Ultimately, the continuous growth of IDZ and SRZ led to the evolution of the substrate from a monocrystalline to a polycrystalline structure. This study provides valuable data on the microstructural evolution of TBCs and the assessment of their service life.

Effect of Hf Addition in (ni,pt)al Bond Coat on Thermal Cycling Behavior of a Thermal Barrier Coating System at 1100 °C

Different Growth Mechanisms of Alumina on the Surface of NiPtAl and MCrAlY Bondcoatings in EB-PVD TBC System

Influences of MCrAlY Coatings and TBCs on Oxidation Behavior of a Ni-Based Single Crystal Superalloy

Effect of Hf Addition on Initial Microstructure of (ni, Pt)Al Coating and Inhibiting the Detrimental Sulfur During High Temperature Exposure at 1150 °C

Investigation on the Performance of Air Plasma Sprayed Thermal Barrier Coating with Lu/Hf-doped NiAl Bond Coat

Co-doping Effect of Hf and Y on Improving Cyclic Oxidation Behavior of (ni,pt)al Coating at 1150 °C

Effect of pre-oxidation on the failure mechanisms of EB-PVD thermal barrier coatings with (Ni,Pt)Al bond coats

Hf and Ta co-doping MCrAlY alloy to improve the lifetime of coatings

Microstructure and Cyclic Oxidation of a Hf-doped (ni,pt)al Coating for Single-Crystal Superalloys

Thermal Failure of Thermal Barrier Coating with Thermal Sprayed Bond Coating on Titanium Alloy

High Temperature Hardness and Thermal Analysis of CoNiCrAlY Alloys Used As Bond Coats for Thermal Barrier Coatings

Pt-Al bond coat dependence on the high-cycle fatigue rupture and deformation mechanisms of a fourth-generation single crystal superalloy at various temperatures

Microstructure and Thermal Cycling Behavior of Thermal Barrier Coating on Near-Α Titanium Alloy

Comparative study of temperature-dependent oxidation and interdiffusion behavior on NiCoCrAlYHf-coated nickel-based single-crystal superalloys

Effect of Temperature on the Tribological Properties of Hafnium Carbonitrides Coatings

Pt-modification on the thermal cycling behavior of NiCoCrAlYTa coating: a case study

Preparation and Enhanced Oxidation Performance of a Hf-doped Single-Phase Pt-modified Aluminide Coating

Clarifying the effects of composition and phase stabilization on the oxidation resistance in AlCoCrFeNiTi series high-entropy alloys at 1100 °C

Modification of NiCoCrAlY with Pt: Part II. Application in TBC with Pure Metastable Tetragonal (t′) Phase YSZ and Thermal Cycling Behavior

Structural characteristics and high-temperature oxidation behaviour of nano-HfO2-doped thermal barrier coatings

Effect of Al content on the oxidation behavior of NiCoCrAlYHf alloys at 1100°C