Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Design and initial characterization of MIC4, the monolithic active pixel sensor prototype for CEPC vertex detector

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

A monolithic active pixel sensor with node-based, data-driven, parallel readout for the high energy physics experiment vertex detector

Data Acquisition System for CEPC Vertex Detector Prototype

Characterization of the first prototype CMOS pixel sensor developed for the CEPC vertex detector

Beam test of a 180 nm CMOS Pixel Sensor for the CEPC vertex detector

High data-rate readout logic design of a 512 × 1024 pixel array dedicated for CEPC vertex detector

M.i.p. detection performances of a 100 us read-out CMOS pixel sensor with digitised outputs

Development of Fast and High Precision CMOS Pixel Sensors for an ILC Vertex Detector

Beam test of a baseline vertex detector prototype for CEPC

Simulations and Performance Studies of a MAPS in 65 nm CMOS Imaging Technology

Mechanical design of an ultra-light vertex detector prototype for CEPC

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

Prototype design of a Monolithic Active Pixel Sensor for the Electron-ion collider in China

Towards a New Generation of Monolithic Active Pixel Sensors

Characterization of a CMOS pixel sensor for charged particle tracking

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Color Bosonization, Chiral Parametrization of Gluonic Field and QCD Effective Action

Silicon detector R$\&$D for the future Electron-Ion Collider

Development of CMOS Pixel Sensors fully adapted to the ILD Vertex Detector Requirements