Abstract:CFRP/Ti stacks have become a viable alternative to conventional composite laminates and metal alloys in various aerospace applications because of their enhanced mechanical properties and improved structural functions. Machining these multilayer stacks with acceptable quality still remains a great challenge for the modern manufacturing sectors due to the ineffective management of the tool wear performance resulting from the varying properties of the stacked constituents. This paper describes, on a fundamental basis, the wear characteristics of polycrystalline diamond (PCD) tipped tools during the orthogonal cutting of CFRP/Ti stacks. Two cutting sequence strategies, i.e., cutting from CFRP to Ti and cutting from Ti to CFRP, were implemented throughout the cutting tests. The experimental results confirm the predominance of the cutting sequence strategy in affecting the CFRP/Ti chip separation and the machined surface quality. The chip adhesion is a most influential factor leading to the disparate influences of the two cutting sequence strategies on the CFRP/Ti cutting responses. The PCD tool suffers severe crater wear due to the Ti phase cutting, while it undergoes minor flank wear owing to its superior wear resistance against abrasive carbon fibers. The wear signatures on the tool-chip contact zone via the scanning electron microscope (SEM) observation reveal that the Ti phase cutting dominates the formation of the tool crater wear land. The edge chipping occurs mainly due to the sudden force variation in the CFRP/Ti interface machining and the inherent brittleness of the PCD material. The fiber orientation seems to have a great impact on the wear behavior of utilized PCD tools by altering the tool-chip contact length.

On the Quantitative Analysis of Drill Edge Wear when Machining CFRP/Ti6Al4V Stacks

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

On the Analysis of Temperatures, Surface Morphologies and Tool Wear in Drilling CFRP/Ti6Al4V Stacks under Different Cutting Sequence Strategies

Experimental Study on Mechanical Drilling of Carbon/epoxy Composite-Ti6al4v Stacks

A Force Sensorless Method for CFRP/Ti Stack Interface Detection During Robotic Orbital Drilling Operations

Processing research on orbital drilling of CFRP/Ti-6Al-4V stacks

Experimental Study on Drilling Mechanisms and Strategies of Hybrid CFRP/Ti Stacks

Analysis of high temperature and mixed tool wear effects on UD-CFRP cutting mechanism in stacks drilling

A Critical Review Addressing Conventional Twist Drilling Mechanisms and Quality of CFRP/Ti Stacks

On the Interpretation of Drilling CFRP/Ti6Al4V Stacks Using the Orthogonal Cutting Method: Chip Removal Mode and Subsurface Damage Formation

Experimental investigation on drilling machinability and hole quality of CFRP/Ti6Al4V stacks under different cooling conditions

Investigation Of Minimum Quantity Lubrication Effects In Drilling Cfrp/Ti6al4v Stacks

Numerical Study of Interface Damage Formation Mechanisms in Machining CFRP/Ti6Al4V Stacks under Different Cutting Sequence Strategies

Numerical study on the chip removal and surface quality of CFRP/Ti6Al4V stacks

Tool Wear Processes in Low Frequency Vibration Assisted Drilling of CFRP/Ti6Al4V Stacks with Forced Air-Cooling

Wear behaviors of PCD and diamond-coated tools during low-frequency vibration-assisted drilling CFRP/Ti stacks

Comparative Study of Minimum Quantity Lubrication and Dry Drilling of CFRP/titanium Stacks Using TiAlN and Diamond Coated Drills

Wear Behavior of Special Tools in the Drilling of CFRP Composite Laminates

Investigation on the cutting responses of CFRP/Ti stacks: With special emphasis on the effects of drilling sequences

Investigation of CFRP damages induced by the interface high temperature and mixed tool wear mechanism in drilling of thin-walled CFRP /Ti stacks

Wear Characteristics of Polycrystalline Diamond Tools in Orthogonal Cutting of Cfrp/Ti Stacks