Abstract:AbstractThe Laue microdiffraction technique was used to investigate the strain field caused by the shot-peening operation and its redistribution after thermal hold or fatigue in a model nickel-based superalloy with an average grain size of 40μm$$40\,{\upmu }\hbox {m}$$. Micrometer and millimeter size mappings showed that the plastic deformation introduced by shot-peening in the whole sample partially relaxes after a thermal exposure at 450∘C$$450^{\circ }\hbox {C}$$ and was fully redistributed by the fatigue of the material, except in the hardened layer close to the sample edge. Diffraction patterns permitted to measure separately the strains related to the average alloy (γ+γ′$$\gamma +\gamma ^{\prime }$$) and to the γ′$$\gamma ^{\prime }$$ phase. No difference was observed between the two deviatoric strain fields. Even if there were small stresses in the inner part of the samples, the sensitivity of the Laue microdiffraction method was large enough to quantitatively characterize the crystal misorientations and the deviatoric strain redistributions. Useful data were provided not only at the grain scale but also at the mesoscopic scale, thus bridging the gap between the sin2ψ$$\hbox {sin}^{2}\psi $$ and Ortner’s methods used to determine residual stresses, respectively, in fine and single-grain microstructures. The obtained results are also of first interest for a quantitative comparison with HR-EBSD measurements in the scanning electron microscope. Energy coupled measurements with an energy-dispersive point detector were also performed to determine the full elastic strain tensors associated with the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. We demonstrated that, for Ni-based superalloys, the accuracy on strains and stresses was, respectively, of the order of 1×10-3$$1\times 10^{-3}$$ and 250 MPa for the diagonal components of tensors. The measurements suffered from the 150 eV resolution of the detector which made it difficult to the separate the energies of the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. Owing to large crystal misorientations, the microdiffraction technique was not able to determine elastic strains and hardening in the highly deformed layer, where a large amount of plastic strain and a number of defects were accumulated. Some improvements are proposed to overcome these difficulties.

Measuring Growth Kinetics Of Individual Grains During Secondary Recrystallisation Using An In-Situ Neutron Diffraction Technique

Analysis of the Growth of Individual Grains During Recrystallization in Pure Nickel

Multiscale in-situ characterization of static recrystallization using dark-field X-ray microscopy and high-resolution X-ray diffraction

Ultra high-temperature deformation in a single crystal superalloy: Meso-scale process simulation and micro-mechanisms

Observation of Dendrite Growth Velocity and Microstructure Transition in Highly Undercooled Single Phase Alloys

Selective growth of recrystallizing grains into well-characterized deformed aluminum at hardness indentation

γ′-size effect on the deformation microstructure and texture in a Ni-based superalloy using in-situ neutron diffraction

Spinodal Decomposition Versus Classical Gamma-Prime Nucleation in a Nickel-Base Superalloy Powder: An In-Situ Neutron Diffraction and Atomic-Scale Analysis

Mesoscopic quantitative chemical analyses using STEM-EDX in current and next generation polycrystalline Ni-based superalloys

Directional recrystallisation in nickel based high temperature alloy

Recrystallization of bulk nanostructured magnesium alloy AZ31 after severe plastic deformation: an in situ diffraction study

Local strain redistribution in a coarse-grained nickel-based superalloy subjected to shot-peening, fatigue or thermal exposure investigated using synchrotron X-ray Laue microdiffraction

Cellular Automata Simulation of Grain Growth of Powder Metallurgy Nickel-Based Superalloy

Investigation of Boundary Migration During Grain Growth in Fully Recrystallised High Purity Nickel

Effect of recrystallisation on microstructural evolution and mechanical properties of single crystal nickel base superalloy CMSX-2 Part 1 - Microstructural evolution during recrystallisation of single crystal

Growth and Coalescence of γ’-Precipitates in Nickel-Based Alloy 115NC during Slow Cooling for Membrane Manufacturing

Investigation on Sub-Solvus Recrystallization Mechanisms in an Advanced γ-γ’ Nickel-Based Superalloy GH4151

Orientation-Dependent Characteristics for Residual Grains During Hot Deformation of Nickel-Based Alloy 925

Kinetics and microstructural evolution during recrystallization of a single crystal superalloy

Microstructure and Microtexture Evolution of Dynamic Recrystallization of a Ni-based Superalloy under High-Throughput Gradient Thermal Compression

Grain-resolved kinetics and rotation during grain growth of nanocrystalline Aluminium by molecular dynamics