Abstract:The radioactive dust in the primary loop of high-temperature gas-cooled reactors (HTGRs) is one of the key challenges to operational safety, particularly in the event of depressurization accidents. To study the behavior of radioactive dust in the primary loop of the HTR-10 reactor, a sampling loop (equipped with a sampling filter) was designed and built in its helium purification system, parallel to the dust filter. Two experiments were conducted using this sampling loop in 2015. The concentrations, particle size distribution of the dust, and typical solid fission and activation products detected in the dust were investigated (Xie et al., 2017). In this paper, we presented the gamma spectra of the three filter elements from the second experiment as well as those of the unused filter elements, for comparison. To further analyze the characteristics of the dust motion during the sampling experiment, the computational fluid dynamics (CFD) method was used to simulate the flow field in the experimental system. Subsequently, we analyzed the transport and deposition behaviors of the dust, and discussed the effects of the diameters and flow rates of the particles on the behavior of the dust. Our calculations indicated that different particle deposition characteristics corresponded to different fillers. We noticed that for the horizontal sampling filter, small particles were more prone to deposit on the first filter, whereas the large particles were more likely to deposit on the bottom surface. Moreover, as the mass flow increased, the effect of gravity decreased. For the vertical dust filter, we noticed that the distance between the deposition location of the particles and inlet increased, while the residence time decreased as the particle size increased. Moreover, the distance between the deposition location and inlet for the small particles increased, while the incidence of the large particles decreased as the mass flow increased. These simulation results could prove valuable for the experimental research of the radioactive dust of HTR-10.

Design and study of radioactive graphite dust experimental system in primary loop of HTR 10

ICONE23-1479 THE RESEARCH PROGRESS ON THE RADIOACTIVE GRAPHITE DUST IN HTR-10

Simulations of the Dust Behavior in the Sampling and Dust Filters in the Primary Loop of HTR-10

The design and thermohydraulics study of the HTR-10 High Temperature Helium Experimental Loop

A Comprehensive Study of the 14C Source Term in the 10 MW High-Temperature Gas-Cooled Reactor

Experimental design on performance improvement of the helium purification system of HTR 10

The Thermohydraulics and Dynamics Study of the HTR-10 High Temperature Helium Experimental Loop

A reform in the helium purification system of the HTR-10: gamma dose rate measurement and suggestions for decommissioning

Research and Measure of Tritium and Carbon 14 in HTR 10

Experimental research on the radioactive dust in the primary loop of HTR-10

Study of Tritium in the Primary Loop of HTR-10: Experiment and Theoretical Calculations

Experimental Investigation of 14C in the Primary Coolant of the 10 MW High Temperature Gas-Cooled Reactor

Experimental Study on the Content and Distribution of Key Nuclides in an Irradiated Graphite Sphere of HTR-10

Experiment and Analysis of Fission Product Activity in Primary-Loop of 10 MW High-Temperature Gas-Cooled Reactor

Source Term Analysis of the Irradiated Graphite in the Core of HTR-10

Experimental Study on Performance Improvement of HTR-10 Helium Purification System

DESIGN OF THE GAS SAMPLING AND ANALYZING SYSTEM OF HTR-PM

Estimation of Graphite Dust Quantity and Size Distribution of Graphite Particle in HTR-10

A Comprehensive Study on Source Terms in Irradiated Graphite Spheres of HTR-10

The R&D of Htgr High Temperature Helium Sampling Loop: from Htr-10 to Htr-Pm

Deposition of Draphite Dust in Heat Gas Duct in HTR-10