Abstract:The precise control of nanomaterial microstructure at the atomic level relies on the comprehensive understanding of atomic structural transition during the fabrication process at the atomic level. The phase transition from protonated titanate to TiO2 is a prevalent route to synthesize low dimensional TiO2-based nanomaterials, which exhibit excellent photocatalytic, lithium-ion battery performances, while the detailed phase transition mechanism remains to be clarified due to lack of atomic-level in situ information. Herein, the atomic structural transitions from one-dimensional H2Ti3O7 (HT) to TiO2(B) and anatase TiO2 (TB and TA) nanocrystals were revealed through in situ environmental transmission electron microscopy, which exhibited a two-step phase transition at 200-600 degrees C. (I) H2Ti3O7 to TiO2(B) transition began via an indirect pathway at similar to 200 degrees C: The HT (200) interlayer dehydration occurred firstly with lattice shrinkage; Then TB discretely nucleated at the dehydrated H2Ti3O7 nanotube wall with a crystallographic relationship of (200)(HT)parallel to(200)(TB) {[001](HT)parallel to[001](TB)}; At higher temperature, the separated nuclei grew up with defects and distorted crystal lattice among them, which then connected and jointed to a single crystalline TB nanotube by atomic rearrangement. (II) The further transition of TiO2(B) to anatase TiO2 occurred via a direct pathway above 400 degrees C: Scarce nucleation event of TA phase was observed, which generated within TB nanocrystal with a crystallographic relationship of (200)(TB)parallel to(002)(TA) {[001](TB)parallel to[010](TA)}. Once a TA nucleus formed, it grew up to a large crystal by consuming the neighbor TB nanocrystals. These findings may contribute to comprehensively understanding phase transition and precisely manipulating the atomic structure of one-dimensional TiO2 nanocrystals.

Transient Thermal Characterization of Single Anatase TiO 2 nanowire with secondary porous structure

Thermal conductivity and secondary porosity of single anatase TiO₂ nanowire.

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

Nonlinear Effects In Transient Electrothermal Characterization Of Anatase Tio2 Nanowires

Thermo-physical Properties of Thin Films Composed of Anatase TiO2 Nanofibers

Temperature-dependent differences in wettability and photocatalysis of TiO 2 nanotube arrays thin films

Rapid-Heating-Triggered in Situ Solid-State Transformation of Amorphous TiO2 Nanotubes into Well-Defined Anatase Nanocrystals

Transient Thermal Characterization of Micro/Submicroscale Polyacrylonitrile Wires

Control of Microscopic Morphology and Structure of One Dimensional Titanium Dioxide Nanomaterials

Crystalline phase transformation of electrospinning TiO2 nanofibres carried out by high temperature annealing

From nanorods to atomically thin wires of anatase TiO(2): nonhydrolytic synthesis and characterization.

Crystalline Transition from H<sub>2</sub>Ti<sub>3</sub>O<sub>7</sub> Nanotubes to Anatase Nanocrystallines Under Low-Temperature Hydrothermal Conditions

Anisotropic Thermal Transport in Highly Ordered TiO2 Nanotube Arrays

An Amorphous-to-Anatase Phase Transition Study of TiO 2 Nanotubes by Temperature-Dependent Synchrotron-Based In Situ X-ray Diffraction

Thermal Transport of Tin Dioxide Nanowires

Synthesis of Anatase TiO2 Nanowires by Modifying TiO2 Nanoparticles Using the Microwave Heating Method

In Situ Revealing the Dehydration and Atomic Structure Evolution of Protonated Titanate Nanotubes Via Environmental Transmission Electron Microscopy

Mesoporous Structure and Phase Transition of Nanocrystalline TiO2

Thermal Characterization of Micro/nanoscale Conductive and Non-Conductive Wires Based on Optical Heating and Electrical Thermal Sensing

Electrical Transport Properties of Polycrystalline and Amorphous TiO2 Single Nanotubes