Abstract:Abstract The KArlsruhe TRItium Neutrino (KATRIN) experiment aims to measure the neutrino mass with a sensitivity of 0.2 eV (90 % CL). This will be achieved by a precision measurement of the endpoint region of the β-electron spectrum of tritium decay. The β-electrons are produced in the Windowless Gaseous Tritium Source (WGTS) and guided magnetically through the beamline. In order to accurately extract the neutrino mass the source activity is required to be stable and known to a high precision. The WGTS therefore undergoes constant extensive monitoring from several measurement systems. The Forward Beam Monitor (FBM) is one such monitoring system. The FBM system comprises a complex mechanical setup capable of inserting a detector board into the KATRIN beamline with a positioning precision of better than 0.3 mm. The electron flux density at that position is on the order of 10 6 s -1 mm -2 . The detector board contains two silicon detector chips of p-i-n diode type which can measure the β-electron flux from the source with a precision of 0.1 % within 60 s with an energy resolution of FWHM = 2 keV. The unique challenge in developing the FBM arises from its designated operating environment inside the Cryogenic Pumping Section which is a potentially tritium contaminated ultra-high vacuum chamber at cryogenic temperatures in the presence of a 1 T strong magnetic field. Each of these parameters do strongly limit the choice of possible materials which e.g. caused difficulties in detector noise reduction, heat dissipation and lubrication. In order to completely remove the FBM from the beam tube a 2 m long traveling distance into the beamline is needed demanding a robust as well as highly precise moving mechanism.

BIF Profile Monitor for the UNILAC-Tests and DAQ Upgrade ∗

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Progress on an Electron Beam Profile Monitor at the Fermilab Main Injector

First Tests of the I-BEAT Detector as Primary Monitor for Target Normal Sheath Accelerated Protons

A prototype scintillating fibre beam profile monitor for Ion Therapy beams

Upgrade of the Diagnostic Neutral Beam Injector for the RFX-mod2 experiment

LET calibration of ion microbeams and their SEE cross-section characterisation

An Instrument for Precision Controlled Radiation Exposures, Charged Beam Profile Measurement, and Real-time Fluence Monitoring Beyond $10^{16}$ n$_{\textrm{eq}}$/cm$^{2}$

Commissioning and first results of the Electron Beam Profiler in the Main Injector at Fermilab

The Frascati Beam Test Facility

Upgrades of beam diagnostics in support of emittance-exchange experiments at the Fermilab A0 photoinjector

Target Multiwire for the Fermilab Booster Neutrino Beamline

The XBPF, a new multipurpose scintillating fibre monitor for the measurement of secondary beams at CERN

Development of a real-time beam profile monitor for GeV photons and its application in accelerator facilities

A system for online beam emittance measurements and proton beam characterization

Beam characterization by means of emission spectroscopy in the ELISE test facility

Direct high-resolution ion beam-profile imaging using a position-sensitive Faraday cup array

Initial PIP-II Beam Current Monitor Fault Case Analyses & Beam Position Monitor Linearity Studies in CST Studio Suite

Forward Beam Monitor for the KATRIN experiment

Commissioning of the laser-driven ion acceleration beamline at the Centre for Advanced Laser Applications