Abstract:A 600-700GHz SIS mixer with the twin-junction tuning circuit has been designed and fabricated [1] The surface impedance of thin-film superconducting microstrip lines, based on Mattis-Bardeen theory [2], is included in the optimization of RF impedance matching. The receiver noise temperature measured in the frequency range of 630-660GHz is below 200K and the lowest receiver noise temperature of 181K is achieved at 656GHz. The FTS response of the SIS mixer shows a good RF coupling from 600GHz to 700GHz. Both the noise performance and the FTS response can be quantitatively described by numerical results using the quantum theory of mixing. Some detail considerations on the mixer model calculation, such as spreading inductance around the junction tuning structure and mixer's embedding impedance, are discussed. Introduction Nb-based superconductor-insulator-superconductor (SIS) mixers have been used very successfully in sub-mm wavelength detection. Their receiver noise temperature has reached to three times the quantum limit, —3 hfrkB, below the junction's gap frequency. However, at high frequency bands, Nb SIS mixers need to be designed carefully because the photon energy is close to or higher than the gap energy of Nb, A-1.4meV. When the frequency band covers the gap frequency of Nb, —670GHz, the RF loss of Nb superconducting transmission lines increases dramatically and the surface impedance has strong frequency dependence. Usually, the RF properties of a superconducting transmission line can be described by the Mattis-Bardeen theory [2] in good accuracy. From results reported so far [4-9], the best receiver noise temperature is close to 5 hi7kB in the band of 600-700GHz. Despite of the input loss contributed by the experimental setup, some other properties of SIS mixers should be taken into account. In this paper, we characterize the performance of a 600-700GHz mixer by comparing the experimental and simulated results.

TH 2-6 1 A 385-500 GHz 2 SI 3 SIS Mixer Based on a Waveguide Split-Block Coupler

A 385-500 GHz 2SB SIS mixer based on a waveguide split-block coupler

A 385–500 GHz Sideband-Separating (2SB) SIS Mixer Based on a Waveguide Split-Block Coupler

TH 2-5 A 385-500 GHz Balanced Mixer with a Waveguide Quadrature Hybrid Coupler

A 385-500 GHz Low Noise Superconductor-Insulator- Superconductor Mixer for ALMA Band 8.

Development of a 385–500 GHz Sideband-Separating Balanced SIS Mixer

A 385-500Ghz Balanced Mixer with a Waveguide Quadrature Hybrid Coupler

Development of the ALMA-North America Sideband-Separating SIS Mixers

A 400–500 GHz Balanced SIS Mixer with a Waveguide Quadrature Hybrid Coupler

Design and Development of SIS Mixers for ALMA Band 10

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 60–90 GHz Mixer-First Receiver with Adaptive Temperature-Compensation Technique

A Sensitive ALMA Band 10 SIS Receiver Engineering Model

Superconducting Receiver Technologies Supporting ALMA and Future Prospects

Performance and Uniformity of Mass-Produced SIS Mixers for ALMA Band 8 Receiver Cartridges

A 290–310 GHz Single Sideband Mixer with Integrated Waveguide Filters

Development of Superconducting Devices Supporting Radio Astronomy.

Three Quanta Sensitivity Superconductor–Insulator–Superconductor Mixer for the 0.78–0.95 THz Band

Performance of the ALMA Band 10 SIS Receiver Prototype Model

Development Of The 787-950 Ghz Alma Band 10 Cartridge

Performance Characterization of a 600-700 GHz SIS Mixer