Abstract:In response to the intricate installation challenges and the elevated cost of sensors for measuring base shear in large‐scale structures, this paper proposes a noncontact measurement method integrating computer vision and model updating to invert structural base shear. The computer vision part measures physical displacement, while the nonlinear model updating section inverts base shear by refining the structural numerical model, thus achieving cost‐effective, noncontact inverting measurements. In the computer vision component, a highly real‐time and accurate optical flow estimation algorithm was selected and validated in actuator motion tracking tests, yielding a normalized root mean square error of less than 3% between displacement tracking and sensor measurable results. The model‐updating section adopts the Bouc–Wen model, demonstrating through numerical simulations its ability to swiftly calibrate the numerical model within 7000 steps under various noise interference levels, accurately obtaining structural base shear. Moreover, the influence of different response combinations and sampling frequencies on parameter identification for model updating is discussed. Findings indicate that when considering both displacement and acceleration, along with a sampling frequency of 200 Hz, parameter identification meets accuracy requirements due to reduced susceptibility to measurement noise. In addition, a shake table test on a three‐layer shear frame is conducted to further validate the proposed method's feasibility. Test results demonstrate that the amplitude and fluctuation trend of the shake table test's identification results mirror those of the numerical simulation results within the first 25 seconds, with a peak value error of 18.9%. While the error is relatively large, this paper provides a practical research framework for model updating and structural health monitoring. Simultaneously, it reduces the cost of acquiring structural response data during tests, thereby facilitating the application and promotion of computer vision technology in structural response monitoring.

Vision-based response measurements for an aeroelastic model of a wind-excited tall building *

A Computer Vision-Based Vibration Measurement Method for Wind Tunnel Tests of High-Rise Buildings

Structural dynamic and aerodynamic parameters identification for a tall building with full-scale measurements

Analysis of Wind Vibration Characteristics of a Narrow-shaped Steel Residential High-rise Building

Wind-induced Stochastic Response of Controlled Tall Buildings by Complex-Mode Analysis

Field Measurement System Based on a Wireless Sensor Network for the Wind Load on Spatial Structures: Design, Experimental, and Field Validation

Variational Mode Decomposition-Based Multirate Data-Fusion Framework for Estimating Structural Dynamic Displacement by Integrating Vision- and Acceleration-Based Measurements

Probabilistic assessment of vibration exceedance for a full-scale tall building under typhoon conditions

Monitoring of structural dynamic behaviors by vision-based system *

A Vision-Based System for Dynamic Displacement Measurement of Long-Span Bridges: Algorithm and Verification

Vision-based Structural Displacement Measurement: System Performance Evaluation and Influence Factor Analysis

Wind Tunnel Tests of an Aeroelastic Model of a Long-Span Transmission Tower

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

Noncontact structural dynamic characteristics identification method and its test verification

Structural Response Analysis and Comfort Evaluation of Residential Buildings: A Combined Wind Tunnel and FEM Approach

Integrated Structural Optimization and Vibration Control for Improving Wind-induced Dynamic Performance of Tall Buildings

Computer vision based target-free 3D vibration displacement measurement of structures

Noncontact Measurement Method for Inverting Structural Base Shear

Wind - Induced Vibration Monitoring and Data Analysis Method for High - Rise Buildings

Calculation of Wind-Induced Responses and Equivalent Static Wind Loads of High-Rise Buildings Based on Wind Tunnel Tests

Experimental Technology on Dynamic Wind Loads on a Tall Building