Abstract:Direct numerical simulations (DNS) of an upward heated pipe flow of supercritical CO2 (at Re0=3600) were carried out with and without conjugate heat transfer (CHT). The aim is to identify the impact of CHT on this specific flow problem and provide information for relevant numerical studies. The configuration is referred to one of the experiments carried out by Luo (2014), with a stainless steel (SS 304) pipe and a thermal activity ratio of 0.061. When CHT is introduced, the predictions of heat transfer coefficient (HTC) and wall temperature obtained in DNS are slightly improved against the experiment measurements. Two primary factors arise when CHT is considered, which are the axial redistribution of wall heat flux and the damping of the enthalpy fluctuations. The former affects the heat transfer particularly within a short distance after the inlet, leading to a more rapid establishment of the thermal boundary layer and a more rapidly progressing ‘laminarising’ process. The latter introduces substantial differences in the fluctuations of enthalpy (∼30 times difference) and density (∼40 times difference), which is however confined within a small region close to the wall and diminishes rapidly further away, resulting in a minor effect on turbulence and heat transfer in the main flow. When CHT is omitted, turbulent kinetic energy is over-predicted up to 1.55 times at most, in particular when the flow is being ‘laminarised’ (z/D<30). This is attributed to the discrepancies in shear production rather than the buoyancy production of the turbulent kinetic energy. Additionally, CHT alters both the laminar (Nul) and turbulent contributions (Nut) to the Nusselt number, with Nul starting at a lower level close to the inlet and the peak of Nut being reduced by 12.3%. These findings provide an insight on the impact of CHT on turbulence and heat transfer at different stages and valuable information for a more accurate modelling method for supercritical fluid flows.

Flow characteristics of helium gas going through a 90 ° elbow for flow measurement

Experimental and Numerical Study on Pressure Distribution of 90° Elbow for Flow Measurement

Characteristics of helium gas flowing through 90° elbow in HTR 10

Characteristics of Helium Gas with High Temperature and High Pressure Flowing Through a 90-Degree Elbow

Feasibility Study of Elbow Flowmeter Used in High Temperature Gas-cooled Reactor

Experimental and Numerical Study on the Circumferential Pressure Distribution on the Wall of a 90° Elbow Pipe with Circular Section

Large eddy simulation of pressure fluctuation in 90° elbow pipe

Experimental and Numerical Investigation of the Flow Measurement Method Utilized in the Steam Generator of Htr-Pm

Study on Flow Characteristics of Helium

Study on the Thermo-Hydrodynamic of a Dry Gas Seal in Helium Circulator for High Temperature Gas-Cooled Reactor

Numerical Investigation of Hot Helium Flow Homogenizer on Inter-Unit Flow Rate Uniformity of HTGR Once Through Steam Generator

Numerical Investigation on Turbulent Flow and Heat Transfer of Helium-Xenon Gas Mixture in a Circular Tube

An Experimental Study on Insulating Property of Helium in High Temperature Gas Cooled Reactor

Numerical Simulation of Flow Field in Hot Gas Chamber of High-Temperature Gas-Cooled Reactor

Numerical Analysis of the Hot Spot of the Heat Transfer Tube Wall in an HTGR Helical Tube Once Through Steam Generator

Investigation on Laminar Flow and Heat Transfer of Helium–Xenon Gas Mixtures with Variable Properties

Impact of Conjugate Heat Transfer on the Turbulence and Heat Transfer in an Upward Heated Pipe Flow at Supercritical Pressure

A Study on the Instantaneous Turbulent Flow Field in a 90-Degree Elbow Pipe with Circular Section

Numerical Investigation on Thermal–hydraulic Characteristics of the Helically Corrugated Tube in Intermediate Heat Exchangers for Very-High-temperature Gas-Cooled Reactors

Helium test loop and test section of hot gas duct

High temperature performance test of hot gas duct of 10 MW high temperature gas-cooled reactor