Ionic Liquid Crystals Confining Ultrathin MoS 2 Nanosheets: A High-Concentration and Stable Aqueous Dispersion
Rui Tian,Xiaohua Jia,Meng Lan,Sizhe Wang,Yong Li,Jin Yang,Dan Shao,Lei Feng,Qingmei Su,Haojie Song
DOI: https://doi.org/10.1021/acssuschemeng.1c08434
2022-03-22
Abstract:To realize the application potential of molybdenum disulfide (MoS2) in aqueous environments, scalable and efficient methods for the preparation of high-concentration and stable dispersions need to be developed. In this paper, ultrathin MoS2 successfully was synthesized using an in situ-exfoliated bulk MoS2 method in water using ionic liquid crystals (ILCs) as green exfoliating/dispersing agents. The ILCs containing hydrophobic cations and hydrophilic anions not only help to exfoliate bulk MoS2 into ultrathin MoS2 nanosheets but also prevent the re-agglomeration of the ultrathin MoS2 nanosheets in water. MoS2 nanosheets were confined by the ILCs through π–π and C–H···π interactions, preventing direct contact of MoS2 with water. The ILC–MoS2 dispersion exhibited remarkable dispersion stability exceeding 8 months at room temperature. Moreover, the ILC–MoS2 dispersion has been successfully proven to be an excellent water-based lubricant, where the ILCs form a lubricant film on the friction surface through electrostatic interactions and MoS2 increases the load-bearing capacity of the lubricant film due to its high modulus, resulting in an 84.9% reduction in the coefficient of friction compared to pure water. The method is expected to provide a new idea for the preparation and application of MoS2.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acssuschemeng.1c08434.Comparison with previous publications; photographs of bulk MoS2, ILC, and ILC–MoS2; photographs of the contact angle of ILCx on bulk MoS2; photographs and concentration of the ILCx–MoS2 dispersion; AFM image of ILC300–MoS2; digital images of the ILC300–MoS2 dispersion after being allowed to stand for different months; TSI index analysis of different parts of the ILC300–MoS2 dispersion; optical images for the wear track width of ILC300–MoS2 for different lateral sizes; average friction coefficient and wear rate of the ILC300–MoS2 dispersion with an average lateral size of 289 nm under different loads and different rotating speeds; optical images for the wear track width of water, ILCs, and ILC300–MoS2 with an average lateral size of 289 nm; and SEM images of the wear surface for pure water and ILCs in water(PDF)1 mL of the ILC300–MoS2 dispersion dropped into 200 mL of deionized water (AVI)This article has not yet been cited by other publications.
chemistry, multidisciplinary,engineering, chemical,green & sustainable science & technology