Abstract:Plastic deformation may occur in a mechanical structure during its manufacturing and service process, and may cause serious problem in the structural integrity. Therefore, a reliable pre-service or in service quantitative non-destructive evaluation (NDE) of plastic deformation is very important especially for a structure after suffering giant load such as a large earthquake. However, there is still no satisfactory method being established for the quantitative NDE of plastic deformation in key structures such as those of a nuclear power plant. For this purpose, three electromagnetic NDE methods, i.e., Magnetic Barkhausen Noise (MBN), Magnetic Incremental Permeability (MW) and Magnetic Flux Leakage (MFL) method are studied via experiments in this paper to investigate their feasibility for evaluation of plastic deformation in carbon steel SS400. A special testing system integrated these three electromagnetic NDE methods is established to measure the magnetic property of test-pieces with different plastic deformation, which was introduced by a tensile testing machine. It is found that the measurement signals of all these three methods have clear correlation with the plastic strains and show coincident tendency, which reveals the validity of these methods for the quantitative evaluation of plastic deformation. Among these methods, the MFL signals are of higher stability and repeatability but of relative low spatial resolution. The MBN method can give better resolution but of bigger standard deviation and is also not valid to evaluate a plastic strain of large scale. On the other hand, the MIP signals are more sensitive to the liftoff of sensor and to the remanent magnetization status, i.e. of more noise. Therefore, to measure the feature parameters of these three methods at the same time with an integrated testing system and to evaluate the plastic strain through signal fusion may give a better detectability and evaluation precision.

Title : Quantitative Evaluation of Residual Strain in Austenitic Stainless Steels using Electromagnetic Nondestructive Evaluation

Depth-Sensing Indentation-Based Studies of Surface Mechanical Behavior and Fatigue Damage Evolution of an Austenitic Stainless Steel Subjected to Cyclic Straining

Evaluation of Residual Strain in the Structural Materials of Nuclear Power Plants

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Evaluation of Plastic Deformation in an Austenitic Stainless Steel based on Nonlinear ECT Method

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Evaluation of Plastic Deformation and Characterization of Electromagnetic Properties Using Pulsed Eddy Current Testing Method

Plastic Strain Measurement with Electromagnetic Acoustic Testing Method Based on Surface Wave

Quantitative Evaluation of Dislocation Density in SUS316L Utilizing Non-Contact Microwave Reflection Method

In Situ Observation of Tensile Experiments on Austenitic Stainless Steel by Espi

Studies On The Correlation Between Natural Magnetization And Mechanical Damages Of An Austenitic Stainless Steel

Investigation of Electromagnetic Properties of 304 Austenitic Stainless Steel with Plastic Deformation and Fatigue Damage and Microstructure Analysis

Stress Evaluation at the Maximum Strained State by EBSD and Several Residual Stress Measurements for Plastic Deformed Austenitic Stainless Steel

Ultrasonic and structural characterization of anisotropic austenitic stainless steel welds: Towards a higher reliability in ultrasonic non-destructive testing

Nondestructive measurement system for welding resdiual stress by ultrasonic method

A Study of Electromagnetic Acoustic Emission Technology in Non-destructive Testing

Quantitative Nondestructive Evaluation of Plastic Deformation in Carbon Steel Based on Electromagnetic Methods

A Study on Influence of Plastic Deformation on the Global Conductivity and Permeability of Carbon Steel

Eddy Current Testing of Residual Stress State in Aluminum Alloy

Quantitative Nondestructive Evaluation of Mechanical Damages Based on the Phenomena of Natural Magnetization

An Experimental Study on the Correlation of Natural Magnetization and Mechanical Damages in an Austenitic Stainless Steel