Effects of nano-TiO2 on combustion and PM emissions of a diesel/methanol dual fuel engine at high loads

Taoyang WU,Chao CHEN,Chunde YAO,Bin WANG,Zhancheng DOU,Hongyuan WEI,Meijuan LIU,Huiran CUI

DOI: https://doi.org/10.13671/j.hjkxxb.2016.0436

2017-01-01

Abstract:An electronic system was installed at the intake pipeline of a turbocharged,inter-cooling electronic unit pump diesel engine,which makes it possible to run in diesel/methanol dual-fuel(DMDF) mode.Experiments were conducted to investigate the effects of nano-TiO2 concentration in methanol and the quantity of methanol injection for constant TiO2 concentration on combustion and PM emission at high load operation.The results showed that explosion pressure was increased and the combustion process was promoted slightly when moderate amount of nano-TiO2,like 30 mg · kg-1 or 100mg·kg-1,was added into methanol.However,it may deteriorate the combustion when excessive additive was used.Emissions of the dry soot and accumulation mode particulate matter significantly decreased by using nano-TiO2,and the decline reached to 26.8％ and 29.4％,respectively when 1000mg·kg-1 additive was used,while it had little effect on nuclear mode particulate.For constant additive concentration in methanol,increasing methanol injection quantity can extend the ignition delay,leading to more concentrated heat release and higher explosion pressure,while the dry soot and PM emissions decreased significantly.Compared to 10％ replacement rate of methanol dispersion,the explosion pressure at 40％ replacement rate increased 0.94 MPa with a 53.5％ incensement in peak of heat release rate.Meanwhile,dry soot,nuclear mode particle number,accumulation mode particle number and the total number of PM reduced by 66.9％,42.3％,67.0％ and 58.0％,respectively.