The alignment of the drift tube linac for the compact pulsed hadron source

Guo Qiankun,Zheng Shuxin,DU Changtong,M. Kaidi,Li Jian,Xing Qing-zi

2018-01-01

Abstract:This paper presents the alignment result of the drift tubes inside the cavity and the DTL cavity in the beam line, together with the progress of the Compact Pulsed Hadron Source (CPHS) project. The CPHS at Tsinghua University is one multi-purpose pulsed neutron source. The linac of the CPHS mainly consists of a proton source, a low energy beam transport line (LEBT), a radio frequency quadrupole (RFQ), and a drift tube linac (DTL). The DTL is positioned downstream the RFQ accelerator and accelerates the beam from 3 MeV to 13 MeV with the peak current of 50 mA to meet the energy demands for the beam bombarding the target. The main structure of the DTL consists of 2 cavities, 39 drift tubes, 2 pedestals and 2 flanges. A total of 41 permanent magnet quadrupoles (PMQs) are mounted in drift tubes and flanges to focus the beam. After the final assembly, the position of each PMQ magnetic center needs to be within the tolerance of ±0.2 mm in the transverse direction and ±0.3 mm in the beam line direction. The alignment measurement of the DTL is one of the key technologies of the CPHS DTL. INTRODUCTION OF CPHS The Compact Pulsed Hadron Source (CPHS) project at Tsinghua University was launched in 2009 [1]. CPHS project consists of a high-current proton linac (13 MeV, 16 kW, peak current 50 mA, 0.5 ms pulse width at 50 Hz), a neutron target station, a small-angle neutron scattering instrument and a neutron imaging/radiology station. The facility will provide the proton beam, together with the neutron beam by delivering the proton beam to bombard the beryllium target. The layout of CPHS is shown in Fig. 1. The CPHS is aimed at becoming an experimental platform for education, research, and innovative applications at Tsinghua University. Figure 1: CPHS project layout The linac of CPHS mainly consists of an ECR ion source, a low energy beam transport line (LEBT), a radio frequency quadrupole (RFQ), a drift tube linac (DTL), and a high energy beam transport line (HEBT). The DTL will accelerate 50 mA proton beams from 3 MeV to 13 MeV to bombard the target [2][3]. The permanent magnet quadrupoles (PMQs) are mounted in the drift tubes with an FD lattice to focus the beam. _________________________________ * Email address: xqz@tsinghua.edu.cn DTL ALIGNMENT REQUIREMENTS The DTL cavity structure mainly consists of 2 cavities, 2 pedestals, 2 flanges and 39 drift tubes. 24 drift tubes are installed in the first cavity and 15 drift tubes are installed in the second cavity. The cavity is shown in Fig. 2, and the drift tubes are shown in Fig. 3. Figure 2: DTL cavity Figure 3: Drift tubes installed in the cavity The CPHS beam line coordinate system is defined as follows: the beam direction is Z+; the vertical upward is Y+, and then X+ can be inferred as shown in Fig. 4. Figure 4: Definition of coordinate system According to the electromagnetic field simulation and the beam dynamics simulation, the position requirement of drift tubes is illustrated in Table 1. The position requirement of cavities is illustrated in Table 2. Table 1: Position tolerance of drift tubes