Abstract:Modal parameter identification via ambient vibration is popular but faces challenges from uncertainties due to unknown inputs and low signal‐to‐noise ratio. Bayesian methods are gaining increasing attention for operational modal identification due to their ability to quantify uncertainties. However, improvements in computational efficiency are needed, particularly when addressing numerous modes and degrees of freedom. To address this challenge, this study proposes an innovative approach, termed the "Bayesian spectral decomposition" method (BSD), employing the decompose‐and‐conquer strategy. This novel method, operating within the frequency domain, identifies each mode individually by exploiting their inherent separated modal characteristics. For each mode, the response spectrum matrix undergoes an eigenvalue decomposition, yielding crucial eigenvalues (incorporating frequency and damping information) and eigenvectors (containing mode shape information). Subsequently, statistical properties of the eigenvalues and eigenvectors are utilized to establish likelihood functions for Bayesian parameter identification. By combining prior information, the posterior probability distribution functions of modal parameters are derived. The optimal solution is then obtained by resolving the maximum posterior probability distribution function problem. To further quantify the uncertainty of modal parameters, Gaussian distributions are employed to approximate the posterior probability distribution functions. The adoption of the decomposition approach circumvents the joint identification of all modal parameters, substantially reducing the parameter dimensions for optimization. Consequently, this strategy leads to decreased computational complexity and significantly improved computational stability. The effectiveness of the BSD is confirmed through simulated data generated from an 8‐story shear building as well as measured data collected from both an experimental shear frame and the Canton Tower. The results demonstrate that the proposed method achieves high accuracy in identifying modal parameters, greatly improves computational efficiency, and effectively quantifies the uncertainties in modal parameters.

Modal identification of Canton Tower using the fast Bayesian FFT method

Structural dynamic and aerodynamic parameters identification for a tall building with full-scale measurements

Probabilistic assessment of vibration exceedance for a full-scale tall building under typhoon conditions

Fast Bayesian modal parameter identification method based on short-time Fourier transform

Bayesian Spectral Decomposition for Efficient Modal Identification Using Ambient Vibration

Automatic Bayesian Modal Identification Method for Structures Based on Blind Source Separation

Damping identification using weighted fitting of Frequency-response-function (WFF) method

Structural modal identification and MCMC-based model updating by a Bayesian approach

Fast Operational Modal Analysis of a Single-Tower Cable-Stayed Bridge by a Bayesian Method

Bayesian Approach for Typhoon-Induced Fragility Analysis of Real Overhead Transmission Lines

Wind-induced Stochastic Response of Controlled Tall Buildings by Complex-Mode Analysis

Hierarchical Bayesian Operational Modal Analysis: Theory and Computations

Assessing uncertainty in fast Bayesian modal identification based on seismic structural responses

Bayesian-guided operational modal identification of a highway bridge considering non-uniform sampling

Bayesian FFT Modal Identification for Multi-setup Experimental Modal Analysis

Modal identification of wind turbine tower based on optimal fractional order statistical moments

Uncertainty quantification in fast Bayesian modal identification using forced vibration data considering the ambient effect

Operational Modal Analysis of Civil Engineering Structures with Closely Spaced Modes Based on Improved Hilbert–Huang Transform

Dynamic Property Evaluation of a Long-Span Cable-Stayed Bridge (Sutong Bridge) by a Bayesian Method

Bayesian uncertainty quantification of modal parameters and RRF identification of transmission towers with limited measured vibration data

Modal Parameters Identification of Time-Varying System Based on Hilbert-Huang Transform