riction behavior of Mg – Al – CO 3 layered double hydroxide prepared y magnesite

I. Wang,Z. Bai,Dong Zhao,F. Zhao

2013-01-01

Abstract:eywords: ayered double hydroxide ubricant material riction performances gravimetric analyzer (DSC–TGA) and scanning electron microscope (SEM). The results show that the modified LDH has platelet morphology with a near hexagon shape. In addition, the tribological properties of GMAC-LDH were evaluated by four-ball friction tester and gear tester. As a lubricant, GMAC-LDH possesses an excellent property on reducing friction and wear of friction pair. The results of friction tests indicated that the friction coefficient, diameter of wear scar and power consumption of the oil with by 11 agnesite GMAC-LDH was reduced . Introduction In recent years, the exploration of nanoparticles used as ubricant materials has received considerable attention owing o their unique properties in anti-wear, reducing friction, and he endurance under extreme pressure [1–3]. Many studies on olid particles, such as elementary substance [4,5], oxides [6,7], orate [8] and layered silicate minerals used as lubricant addiives have been reported. In some papers, serpentine was served s anti-frictional and self-repairing materials. According to the xperimental results, serpentine could significantly reduce friction oefficient and wear of friction pairs. Yu [9] found that the addiion of 1.5 wt% serpentine (layered silicate mineral) to oil with the oad at 100 N could decrease the friction coefficient by 50.6% and the ear rate of disk specimen by 82.3% as compared to pure oil. On the asis of Zhao [10], the friction coefficient of base oil with 0.5 wt% erpentine could be reduced by 21.83% compared with the base il. Although the serpentine has superior performance in reducing riction coefficient and anti-wear, the processes, such as ultrafine owders, surface modification and activating treatment, may be omplex before natural minerals are used as anti-frictional and selfepairing materials. In addition, the particle size of serpentine is ifficult to control [11]. The materials with simple synthesis process nd controlling granulation are needed to be utilized as lubricant aterial. ∗ Corresponding author. Tel.: +86 13717841830; fax: +86 10 82323201. E-mail address: wxbdyxiang@126.com (X. Wang). 169-4332/$ – see front matter © 2013 Elsevier B.V. All rights reserved. ttp://dx.doi.org/10.1016/j.apsusc.2013.04.014 .0%, 8.5% and 2.1% as compared with that of base oil. © 2013 Elsevier B.V. All rights reserved. Layered double hydroxides (LDHs), also known as anionic or hydrotalcite-like clays, are a class of layered compounds that consist of positively charged brucite-like host layers and hydrated exchangeable anions located in the interlayer gallery for charge balance. The charge of the brucite-like layers was due to the isomorphous substitution of a part of the divalent metal ions by trivalent ones [12]. The general chemical composition of LDH is [M1−xMx (OH)2]x+(An−)x/n·mH2O, where M2+ and M3+ are divalent and typically trivalent metal cations respectively on the layer; x is the molar ratio of the trivalent cation [M3+/(M2++M3+)]; An− is the interlayer anions with the charge n and m is the amount of H2O interlayer. LDHs have been found in a wide variety of uses, such as adsorbents, catalysts, catalyst supports, biosensors and magnetic materials [13–15]. Recently, the LDH used as lubricant additive was reported. Fu [16] reported that the friction coefficient of oil with Cu–Mg–Al–CO3 LDHs could be reduced 32% in comparison with base oil. Bai [11] delivered a paper about the friction performances of Co–Al–CO3 layered double-metal hydroxides. The result indicated that Co–Al-LDHs could significantly reduce friction coefficient and energy consumption of driving motor by 49.1% and 7.0% respectively. The experimental result of Zhao [17] shown that the Mg–Al–CO3 LDH prepared by chemical reagents has excellent property in friction-reduce, with the friction coefficient decreased by 23.9% comparing with base oil. In addition, LDHs were easy obtained by many ways [18–21], the granularity of which could be also controlled through synthetic conditions. Because of these advantages, LDHs may be widely used as lubricant material. In this paper, Mg–Al–CO3 layered double hydroxide prepared with magnesite was modified by sodium laurate solution to face Science 277 (2013) 134– 138 135