Abstract:This paper establishes a new model for predicting machined surface topography and anisotropic texture direction in peripheral milling. Unlike previous models, this model takes into account the largest number of influential factors, i.e., tool setting error (radial offset and axial tilt), static tool deflection, forced vibration, chatter vibration, and stochastic tool grinding error and wear (STGEW). STGEW, quantified by the normal distribution (mu, sigma(2)), is incorporated into the model for the first time. The model predictions for 3D surface topography, anisotropic texture direction, 2D surface profile or roughness agree remarkably well with experimental or published results, under both stable and unstable milling conditions. It is found that static deflection slightly attenuates the effect of tool setting error on roughness. Even machining with fresh tools or tools with very small cutting length (<15 mm) and wear (VB similar to 5 mu m), inherent STGEW creates random scratches with different geometries parallel to feed direction on the milled surface. STGEW expands the difference of roughness in axial direction. STGEW induces an additional surface texture in feed direction, which co-exist with axial texture contributed by feed marks when standard deviation sigma to feed rate f(t) ratio is small. As sigma increases, (1) feed marks are gradually obliterated by scratches, and surface texture is only oriented in feed direction; (2) the mean and variance of roughness in both directions increase, and axial roughness prevails transverse toughness at high u. The study discovers that, STGEW, even with small sigma (e.g., sigma=[0.01 mu m, 0.1 mu m]), is an important factor affecting surface topography, anisotropic surface texture direction and roughness that cannot be ignored, especially in the case of low-feed machining, e.g., f(t) = 0.05 mm, which is commonly adopted in finish-milling of difficult-to-cut materials. The proposed model can be used to reliably and accurately predict surface topography, surface roughness and surface texture direction in peripheral milling operation.

Effect Of Uncertainty On Prediction Of Tool Life For Milling Ultrahigh Strength Steel

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Tool wear rate prediction in ultrasonic vibration-assisted milling

Research on the Milling Tool Wear and Life Prediction by Establishing an Integrated Predictive Model

Tool Quality Life during Ball End Milling of Titanium Alloy Based on Tool Wear and Surface Roughness Models

Influence of Tool Assembly Error on Machined Surface in Peripheral Milling Process

An Investigation into Methods for Predicting Material Removal Energy Consumption in Turning

Modelling of Machined Surface Topography and Anisotropic Texture Direction Considering Stochastic Tool Grinding Error and Wear in Peripheral Milling

A New Prediction Method of Tool Life Considering Cognitive Uncertainty by Delayed Rejection Adaptive Sampling.

Tool remaining useful life prediction and parameters optimization in milling 508III steel

An intelligent prediction model of the tool wear based on machine learning in turning high strength steel

Analytical modeling of milling residual stress under different tool wear conditions

Tool wear estimation and life prognostics in milling: Model extension and generalization

Force prediction in ultrasonic vibration-assisted milling

Influence and prediction of tool wear on workpiece surface roughness based on milling topography analysis

Prediction of undeformed chip thickness distribution and surface roughness in ultrasonic vibration grinding of inner hole of bearings

Three-Stage Wiener-Process-Based Model for Remaining Useful Life Prediction of a Cutting Tool in High-Speed Milling

Online monitoring model of micro-milling force incorporating tool wear prediction process

Prediction of tool wear during micro-milling Inconel 718 based on long short-term memory network

The prediction of 3D surface topography in a high-speed micro-milling process with aerostatic spindle

Residual stress prediction in ultrasonic vibration–assisted milling