Abstract:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, Ahead of Print. By studying the workpiece-edge-coupling (WEC) in five-axis ball-end milling, the contact characteristics between the workpiece and edge curve are analyzed, and the chip model is extracted and simplified. The edge curve involved in the cutting process of each edge are calculated at each time and a new instantaneous numerical chip thickness model is established. Then the milling forces and stability lobe diagram (SLD) are calculated in following cut process with lead and tilt angle. The milling forces and SLD of lead angle at 15° and tilt angle at −15° are verified by comparing with Otzurk model as references, and it is found the SLD of WEC model can reflect the unstable points more properly than that of Otzurk model. Also the vibration in [math] and [math] directions show a divergence trend, which proves the high precision for the new algorithm adapted to the stability prediction of five-axis ball-end milling process. In addition, the surface topography is acquired considering lead and tilt angle as well as forced vibration, and the result is consistent with the experiment in the existing literature. It is found that the milling forces, SLD and surface topography show the same variation trend with the increase of lead and tilt angle. Besides, the stability region significantly expands and the surface topography improves by applying positive tilt angle other than the negative. Then, under the conditions of positive lead and tilt angle, increasing lead angle and decreasing tilt angle reduces the milling force, expands the stability region of SLD and improve the surface topography. The optimized tool posture is acquired by the coincident analysis of milling force, SLD and surface topography under different lead and tilt angle.

The prediction of 3D surface topography in a high-speed micro-milling process with aerostatic spindle

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Relationship between dynamic characteristics of air film of aerostatic spindle and mid-frequency of surface topography

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Geometry Simulation and Evaluation of the Surface Topography in Five-Axis Ball-End Milling

Surface topography prediction in peripheral milling of thin-walled parts considering cutting vibration and material removal effect

3D bevel surface topography analysis and roughness prediction by considering the cutter-workpiece dynamic interaction

An integrated machine-process-controller model to predict milling surface topography considering vibration suppression

Study on Analytical Model of Surface Roughness Prediction in NC Machining

Prediction of Surface Topography in Robotic Ball-End Milling Considering Tool Vibration

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

3D Surface Topography Prediction in the Five-Axis Milling of Plexiglas and Metal Using Cutters with Non-Uniform Helix and Pitch Angles Combining Runout

Precision Prediction of Surface Roughness in High Speed Peripheral Milling Ti6Al4V Alloy

Modeling and prediction of spindle dynamic precision using the Kriging-based response surface method with a novel sampling strategy

Modeling and simulation of surface topography in five-axis ball end milling

A surface quality prediction model considering the machine-tool-material interactions

Model for Surface Topography Prediction in Cylinder Turning

Model for the prediction of 3D surface topography and surface roughness in micro-milling Inconel 718

An accurate 3D surface topography model for single-point diamond turning

A novel approach of stability and topography prediction in five-axis ball-end milling process through workpiece-edge-coupling

Research on the dynamic characteristics of the ultra-precision fly cutting machine tool and its influence on the mid-frequency waviness of the surface