Abstract:Gas turbine engines play a crucial role in numerous industrial domains, including power generation, aviation, and marine propulsion. One of the major challenges in designing gas turbine engines is managing the high temperature generated by the combustion process. Internal cooling is a commonly used technique to maintain the temperature of critical components, such as turbine blades, within a safe operating range. Rib turbulators are widely used in internal cooling systems to enhance heat transfer performance by promoting turbulence in the fluid flow. Nevertheless, the existence of a continuous rib within the cooling channel can result in elevated temperatures near the rib section, potentially diminishing the overall system efficiency. In response to this challenge, a new rib turbulator design, denoted as the “separated rib,” has been introduced to mitigate the high-temperature zone. Through the utilization of the passing-gap design in the separated rib configuration, the coolant flow passes through the gap, effectively eliminating the region of extreme heat and augmenting the secondary flow. Consequently, it results in a notable enhancement of heat transfer performance within the ribbed channel. The numerical simulations are performed by solving three-dimensional (3D) Reynolds-averaged Navier–Stokes equations using the commercial software ANSYS CFX. The working fluid is steam, and the heat transfer performance is evaluated in terms of the Nusselt number (Nu), friction factor (f), and thermal performance factor (TPF). The results show that the separated rib configuration has approximately 17.3% higher Nusselt number than the original ribbed configuration when the Reynolds number (Re) changes from 5000 to 60 000. The separated rib configuration consistently shows higher TPF values between about 1.6 and 1.9 than the original rib configuration, where TPF is smaller than 1.35. Furthermore, the heat transfer correlation related to the Reynolds number was developed to predict heat transfer performance. The heat transfer correlations align closely with the numerical simulation results, showing about 17.4% and 34.3% improvements in Nu and TPF, respectively, for our newly designed system compared to the old version.

Numerical Simulation of a Gas Film-cooled Flat Plate Channel

Numerical Simulation of Gases over Flat Plate Using Two-Temperature Nonlinear Coupled Constitutive Relations

Experimental and numerical study of the effect of conjugate heat transfer on film cooling

Experimental and Numerical Investigation of Convection Heat Transfer in a Rectangular Channel with Angled Ribs

Conjugated Heat Transfer Analysis Of A Film Cooling Passage With Different Rib Configurations

Numerical Simulation the Effect of Inlet-outlet-tube Position on Plate-fin Oil Cooler

Numerical Simulation of Fluid Flow and Convection Heat Transfer in Sintered Porous Plate Channels

CONJUGATED HEAT TRANSFER ANALYSIS OF A FILM COOLING PASSAGE WITH TURBULATOR RIBS

Numerical Simulation on Heat Transfer Augmentation by Using Innovative Hybrid Ribs in a Forward-Facing Contracting Channel

Numerical Study on Heat Transfer Performance of a New-proposed Pin-fin in an Internal Channel

CFD Simulation of Fluid Flow and Heat Transfer in Channels of Plate-Fin Heat Exchangers

Numerical investigation of the flows and heat transfer characteristics of internal cooling channels with separated ribs in gas turbine blades

Heat Transfer and Pressure Loss Simulations of Matrix Cooling Channels for Gas Turbine Airfoils

Numerical Study of Film Cooling of a Flat Plate at Different Blowing Ratios

Numerical study on laminar flow forced‐convection heat transfer for air in a channel with offset plates heated by radiation heat flux

Heat Transfer and Fluid Flow Characteristics of Microchannel with Discrete Double Inclined Ribs on Sidewalls

Effect of Ribs on Heat Transfer and Pressure Drop in a U-Bend Channel With Double-Layer, Dome-Shaped Turning Vanes

Three-Dimensional Numerical Simulation on the Laminar Flow and Heat Transfer in Four Basic Fins of Plate-Fin Heat Exchangers

Experimental and Numerical Investigation of Convection Heat Transfer in Channels with Different Types of Ribs

Three dimensional numerical simulation on surface performance of a plate-fin heat exchanger.

Numerical Simulation of Stability Behaviors and Heat Transfer Characteristics for Near-Critical Fluid Microchannel Flows