Abstract:Owing to their low cost and reduced power losses, floating bush bearings are extensively used in high-speed rotors. The advantages are mainly the result of the rotation of the bush. When shaft speed is within a low speed range, bush rotation speed increases linearly with shaft speed. However, the bush-to shaft speed ratio decreases sharply when the shaft speed reaches a certain range. The mechanism of this phenomenon is not completely clear yet, and a precise prediction method has not been established. The traditional theoretical model predicts that the speed ratio remains constant even when the shaft speed reaches the certain range. Some researchers have attempted to improve the prediction model by considering thermal effect on the assumption that a temperature increase decreases the viscosity of the inner oil film and consequently reduces the speed ratio. However, temperature rise alone is insufficient to induce that much drop of speed ratio. This paper focuses on the effect of air invasion flow in the inner oil film from the axial ends and evaluates the importance of air invasion and thermal effects. Computational fluid dynamics (CFD) modeling is adopted in this study because of its capacity to handle complicated calculation domain and calculate air-oil two-phase flow. Three series of CFD simulations with different models are conducted. These models consider the thermal effect (thermal model), the air invasion effect (air model), and the combination of the thermal and air invasion effects (hybrid model). CFD results of the different models are compared to weigh the importance of each effect. The CFD calculation indicates that a substantial amount of air invades the inner oil film when the shaft speed reaches a certain range. Speed ratio drop is not Caused by a single factor, but it is the result of the combination of the air invasion and thermal effects. Air invasion, which researchers previously ignored, plays a greater role than the thermal effect.

Numerical Investigation of Subsynchronous Vibration in Floating Ring Bearings

Numerical Investigation of Air–Oil–Thermal Coupling Mechanism in Floating Ring Bearings

Experimental and numerical investigation on thermodynamic performance of full-floating ring bearings with circumferential oil groove

Lubrication and stability analysis of nonlinear rotor-bearing system

Coupling analysis of tribological and dynamical behavior for a thermal turbulent fluid lubricated floating ring bearing-rotor system at ultra-high speeds

Numerical and Experimental Investigation on Thermohydrodynamic Performance of Turbocharger Rotor-Bearing System

Effects of Semi-floating Ring Bearing Outer Clearance on the Subsynchronous Oscillation of Turbocharger Rotor

Dynamic Analysis of Turbocharger Rotor Bearing with an Integrated Three Dimensional Thermohydrodynamic Model

Investigation Of Air-Oil-Thermal Distribution In Floating Bush Bearings

Vibration characteristics of turbocharger rotor system considering internal thread texture parameters of semi-floating ring bearing

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

A Numerical Investigation of the Effects of Groove Texture on the Dynamics of a Water-Lubricated Bearing–Rotor System

Influence of Cavitation Pressure on Performance of Sliding Bearings

Numerical Investigation of Turbulence Models for a Superlaminar Journal Bearing

Transient nonlinear dynamics of the rotor system supported by low viscosity lubricated bearing

Analysis of Dynamic Characteristics of Ring Squeeze Film Damper-Rotor System

Investigation on the nonlinear dynamic behaviors of water-lubricated bearings considering mixed thermoelastohydrodynamic performances

Dynamic characteristics of high-speed gasoline engine turbocharger based on thermo-elasto-hydrodynamic lubrication bearing model and flexible multibody dynamics method

Dynamic characteristics analysis of an elliptical bearing-rotor coupled system

Direct Observation of Cavitation Phenomenon and Hydrodynamic Lubrication Analysis of Textured Surfaces

An Improved Dynamic Modelling for Exploring Ball Bearing Vibrations from Time-varying Oil Film