Abstract:Gas-liquid two-phase swirling flow is widely used for gas-liquid separation in the power, chemical, petroleum, and nuclear industries. However, the majority of current research on swirling flow focuses on identifying flow patterns and does not pay more attention to topics such as the boundary where swirling flow forms. The length and diameter of the central gas core are the main focus of the current studies as well as the distribution patterns of gas-liquid two-phase. Comparative studies on the gas-liquid distribution morphology, such as whether the gas phase is separated and the separation mode, are lacking. In this paper, a combination of visual experimental observations and numerical simulations of Computational Fluid Dynamics (CFD) is used to investigate the formation conditions of gas-liquid two-phase swirling flow in three types of cyclonic components. The results show that the minimum superficial liquid velocity for the formation of swirling flow in the horizontal tube is about 0.375~0.82 m/s when the superficial gas velocity is less than 10 m/s. The formation of swirling flow is almost independent of the geometric swirl number and superficial liquid velocity when the superficial gas velocity is greater than 10 m/s. At low inlet superficial velocities, the tangential velocity determines the transition from swirling flow to stratified flow. However, at higher inlet superficial velocities, the decay of the cyclonic field is mainly affected by the wave amplitude of the gas-liquid interface. In both co-current and counter-current horizontal inline gas-liquid cyclone separators, the flow split is related to the vortex core breakdown of the central gas core. In addition, the numerical simulation results show that the breakdown of the vortex core is related to the pressure distribution inside the separator. This work enriches the study of swirling flow and provides a basis for the performance improvement of inline gas-liquid cyclone separators.

Influencing Factors of Air-to-liquid Ratio in Vacuum Drainage Systems and Determination of Their Values

Modeling and parameter estimation of distillation vacuum system with a recovery device

Structural Parameter Optimization of Hydraulic Vertox Separator in Recirculating Biofloc Technology System Based on Computational Fluid Dynamics

Relationship between fluctuating differential pressure and void fraction of gas-liquid two-phase flow in Venturi tube

Separation mechanism and influential factor study on vane-type-associated petroleum gas separator

Analysis of Condition of Ensuring High-Lift Siphon Drainage and Numerical Simulation of Choice of Optimum Diameter

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Hydrodynamic Character of Internal-Loop Airlift Reactor

The Design of A Degassing Pump Based on Numerical and Experimental Research

Experimental research and numerical analysis for effect of drainage structure on separation performance and the "blockage" of fluid in nozzle

Flow Performance Analysis of Double-Chamber Gas–Liquid Transferring Device

Simulation And Experimentation On The Gas Holdup Characteristics Of A Novel Oscillating Airlift Loop Reactor

Gas Holdup and Liquid Circulation Velocity in Gas-Liquid Two Stage Internal Loop Airlift Reactor

Investigation on key geometries optimization and effect of variable operating conditions of a transcritical R744 two-phase ejector

Liquid Circulation Velocity and Local Gas Holdup in Air-lift Loop Reactor

Design and Experimental Study of Negative Pressure Spiral Separation and Reduction Device for Drilling Holes

LOCAL HYDRODYNAMICS IN AN EXTERNAL LOOP AIRLIFT SLURRY REACTOR WITH AND WITHOUT A RESISTANCE-REGULATING ELEMENT

Hydrodynamic Behavior in Three-Phase External Loop Airlift Reactors

Influence and mechanism of solids on the air pressure fluctuations on the building drainage system

Research on the Gas-Liquid Two-Phase Distribution Behavior and Influencing Factors of Swirling Flow in Horizontal Pipe

Effect of working fluid temperature on energy dissipation characteristics of liquid ring vacuum pump