Abstract:Evaporative emission is an important source of vehicle pollutant emission and volatile organic compounds (VOCs), causing serious environmental pollution. Carbon canisters are used to store fuel vapor in evaporative emission control (EVAP) system, but canisters are prone to saturation, leading to the direct release of fuel vapor into the atmosphere. Therefore, accurate estimation of fuel vapor generation is crucial for EVAP system. Gasoline evaporation rate is mainly influenced by vapor-liquid interface area, gasoline saturated vapor pressure, filling level and temperature. The quantitative relation between different parameters and gasoline evaporation rate has rarely been reported, and a gasoline evaporative emission estimation model suitable for China needs to be proposed urgently. In this study, gasoline evaporative emission tests have been carried out in VT-SHED, and the effects of vapor-liquid interface area, filling level and temperature on gasoline evaporative emissions have been analyzed under the premise of consistent gasoline temperature and ambient temperature. Some valuable conclusions are obtained. The results show that different from expectation, gasoline evaporative emissions are not positively correlated with the vapor-liquid interface area. There is an approximately exponential relationship between the headspace volume and gasoline evaporative emissions. The widely used Reddy equation and Hata equation underestimate the gasoline vapor generation in China. Based on China VI test program and gasoline, accurate estimation of mass transfer coefficient has been conducted, and a new semi-empirical estimation model for vapor generation has been proposed. The model can accurately estimate the fuel evaporation of vehicles in China, providing guidance for the matching and optimization of EVAP system.

Modeling and parameter estimation of distillation vacuum system with a recovery device

NON-EQUILIBRIUM MODEL BASED LARGE-SCALE PARAMETER ESTIMATION FOR THREE-PHASE DISTILLATION IN PACKED COLUMNS

Estimation of Time-Dependent Parameters of a Heat-Integrated Distillation Column System

Flow pattern identification for three-phase distillation with a nonequilibrium modeling

Empirical Modelling and Advanced Control of an Industrial Distillation Column

Nonequilibrium model and parameter estimation on three-phase distillation in a packed column

MODELING OF BATCH DISTILLATION STARTING FROM COLD STATE

Aggregated Model High Purity Distillation Column Based on Group Methods

Implementation of Parameter Estimation in Mechanistic Models by Dynamic Optimization

Methodology of data reconciliation and parameter estimation for variable load in process system

Heat and mass transfer model for desiccant solution regeneration process in liquid desiccant dehumidification system

A Model for the Prediction of Bubble Detachment Diameters in Vapor Compression Distillation Assembly

Compartmental modeling and solving of large-scale distillation columns under variable operating conditions

DESIGN OF INTEGRATED PROCESS OF DISTLLIATION AND PERVAPORATION FOR THE SEPARATION OF MTBE-C4-METHANOL MIXTURE

A Theoretical Fundamental Investigation on Boilers Equipped with Vapor-Pump System for Flue-Gas Heat and Moisture Recovery

Design and dynamic behaviour investigation of a novel VOC recovery system based on a deep condensation process

Waste Heat and Water Recovery from Natural Gas Boilers: Parametric Analysis and Optimization of a Flue-Gas-driven Open Absorption System

Dynamic study of water distillation detritiation process startup using rigorous and ANN models

Experimental research and estimation model of gasoline evaporative emissions from vehicles in China

A novel mechanical vapor compression vacuum belt drying system: Model development, experimental verification and performance prediction

Modelling of dynamic mass transfer in a vapour extraction heavy oil recovery process