Abstract:In micro-electrical discharge machining (micro-EDM) milling, the cross-section of the microgroove machine is frequently not an ideal rectangle. For instance, there are arc shapes on the bottom and corners, and the sidewall is not steep. The theoretical explanation for this phenomenon is still lacking. In addition to the tip discharge effect, the essential reason is that there is an accumulative difference in time and space during the shape change process of a tool electrode and the microstructure formation on a workpiece. The process parameters are critical influencing factors that determine this accumulative difference. Therefore, the accumulative difference mechanism in time and space is investigated in this paper, and then a theoretical model is developed to simulate the micro-EDM milling process with a straight-line single path. The simulation results for a cylindrical electrode at the two rotational speeds of 0 (nonrotating) and 300 rpm are compared, while the results for a cylindrical electrode and a square electrode at a rotation speed of 0 are also compared to verify that different process parameters generate accumulative differences in the time and space of material removal. Finally, micro-EDM milling experiments are carried out to verify the simulation model. The maximum mean relative deviation between the microgroove profiles of simulation results and those of experiments is 11.09%, and the profile shapes of simulations and experiments have a good consistency. A comparative experiment between a cylindrical electrode and a hollow electrode is also performed, which further verifies the mechanism revealed in the study. Furthermore, the cross-section profile of a microgroove can be effectively controlled by adjusting the process parameters when utilising these accumulative differences through fabricating a microgroove with a V-shaped cross-section by a square electrode and a microgroove with a semi-circular cross-section by a cylindrical electrode. This research provides theoretical guidance for solving the problems of the machining accuracy of detail features in micro-EDM milling, for instance, to machine a microgroove with an ideal rectangular cross-section.

Experimental Study on Micro ECM Variable Cross-sectional Hole by Variable Parameters

Research on Ecm Process of Micro Holes with Internal Features

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Impact Analysis of Electrolyte Pressure on Shape Accuracy of Micro Holes in ECM with Hollow Electrodes

Simulation and Experimental Research on Electrochemical Machining of Cross Groove

Research on Improvement of Accuracy of Micro ECM with Multitechnique Integration

Study On Micro Electrochemical Machining At Micro To Meso-Scale

Electrochemical Machining for Micro Holes with High Aspect Ratio on Metal Alloys Using Three-Electrode PPS in Neutral Salt Solution

Electrochemical Micromachining Based on Multifunction Machine Tool

An Investigation into Accumulative Difference Mechanism in Time and Space for Material Removal in Micro-EDM Milling

Study on Micro-hole Electrochemical Machining Process with Sidewall-insulated Tool Electrode

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds

Analysis and Experimental Study of Micro ECM with Intermittent Retraction of Electrode

Research On Micro Ecm Using Micro Array Electrode

Pulsed Micro-Electrochemical Machining Technology

Performance improvement of high-speed EDM and ECM combined process by using a helical tube electrode with matched internal and external flushing

Micro Electrical Discharge Machining of Small Hole in Tc4 Alloy

Experimental Investigation to Improve the Efficiency and Surface Integrity of Deep Micro-Hole Machined by Micro-Edm

Study on Non-electric Parameters of Inner Jetted Dielectric Small Holes in Micro-EDM

Research On Micro Electrode Fabrication Based On Ecm

Micro Electrochemical Machining for Tapered Holes of Fuel Jet Nozzles