Abstract:Currently, there is great demand for automated assembly of equipment inside spacecraft module, which would require an assembly robot with small size, large workspace, high load capacity, and high flexibility. To meet this demand, a redundant seven-degree-of-freedom (7-DOF) assembly robot with three prismatic joints and four rotating joints is proposed in this study. First, a kinematic model of the assembly robot is established, and the positional forward kinematics are derived. Then, the positional inverse kinematic equations are derived by using the fixed joint method and the coordinate inverse transformation method for the characteristics of the robot with redundant degrees of freedom. The inverse solution optimization model of the assembly robot is designed based on genetic algorithm, and B-spline interpolation algorithm is used for joint trajectory planning. Next, NSGA-2 algorithm is used to construct the trajectory optimization model, and the time-pulsation multi-objective Pareto optimal frontier is obtained. Finally, the joint simulation model of mechatronics and the prototype experiment are established to verify the effectiveness of the optimization results. Analysis shows that the proposed assembly robot has better load-bearing capacity and dynamic characteristics than similar existing assembly robots. Furthermore, the segmented trajectory optimization strategy for the assembly robot using inverse solution optimization, interpolation algorithm, and NSGA-2 based multi-objective optimization gets each motion joint to realize the trajectory tracking function quickly and stably, and the trajectory tracking error is small enough to meet the requirements of end positioning accuracy.

Design of a Serial-Parallel 7-DOF Redundant Anthropomorp Hic Arm

Development of a redundant anthropomorphic hydraulically actuated manipulator with a roll-pitch-yaw spherical wrist

Design Paradigm for Human Size Manipulator with High Payload, Repeatability, and Bandwidth

Design and Development of the Dual-Arm Robot DARO

Conceptual design and dimensional synthesis of a novel parallel mechanism for lower-limb rehabilitation

Design of an anthropomorphic dual-arm robot with biologically inspired 8-DOF arms

Innovative Design Research on a Cable-Driven Humanoid Robotic Arm

Design and Control of a Novel Six-Degree-of-Freedom Hybrid Robotic Arm

Real-time Collision Avoidance for 7-DOF Redundant Anthropomorphic Arm

Parallel, Modular Fabric Actuators for a 2-DOF Pneumatic Sleeve

Design of 6-DOF Parallel Microrobotics Mechanism

Kinematic Analysis and Design of a Novel (6+3)-DoF Parallel Robot with Fixed Actuators

Kinematic Analysis and Design of a Novel Shoulder Exoskeleton Using a Double Parallelogram Linkage

Design and motion planning of a 7-DOF assembly robot with heavy load in spacecraft module

Dexterity, Workspace and Performance Analysis of the Conceptual Design of a Novel Three-legged, Redundant, Lightweight, Compliant, Serial-parallel Robot

Configuration and Parameter Optimization Design of a Novel RBR-2RRR Spherical Hybrid Bionic Shoulder Joint

Design of an Anthropomorphic, Compliant, and Lightweight Dual Arm for Aerial Manipulation

Design and Stiffness Analysis of a Novel 7-DOF Cable-Driven Manipulator

Dual-arm robot modular joint design and error analysis

Optimization of Comprehensive Performance of Planar Redundant Parallel Manipulator

Design of a wearable shoulder exoskeleton robot with dual-purpose gravity compensation and a compliant misalignment compensation mechanism