Abstract:Friction compensation is particularly important for motion trajectory tracking control of pneumatic cylinders at low speed movement. However, most of the existing model-based friction compensation schemes use simple classical models, which are not enough to address applications with high-accuracy position requirements. Furthermore, the friction force in the cylinder is time-varying, and there exist rather severe unmodelled dynamics and unknown disturbances in the pneumatic system. To deal with these problems effectively, an adaptive robust controller with LuGre model-based dynamic friction compensation is constructed. The proposed controller employs on-line recursive least squares estimation (RLSE) to reduce the extent of parametric uncertainties, and utilizes the sliding mode control method to attenuate the effects of parameter estimation errors, unmodelled dynamics and disturbances. In addition, in order to realize LuGre model-based friction compensation, the modified dual-observer structure for estimating immeasurable friction internal state is developed. Therefore, a prescribed motion tracking transient performance and final tracking accuracy can be guaranteed. Since the system model uncertainties are unmatched, the recursive backstepping design technology is applied. In order to solve the conflicts between the sliding mode control design and the adaptive control design, the projection mapping is used to condition the RLSE algorithm so that the parameter estimates are kept within a known bounded convex set. Finally, the proposed controller is tested for tracking sinusoidal trajectories and smooth square trajectory under different loads and sudden disturbance. The testing results demonstrate that the achievable performance of the proposed controller is excellent and is much better than most other studies in literature. Especially when a 0.5 Hz sinusoidal trajectory is tracked, the maximum tracking error is 0.96 mm and the average tracking error is 0.45 mm. This paper constructs an adaptive robust controller which can compensate the friction force in the cylinder.

Research of Compensation Based on Force Ripple of Linear Motor for Precision Stage

A New Linear Motor Force Ripple Compensation Method Based on Inverse Model Iterative Learning and Robust Disturbance Observer.

Adaptive Robust Motion Trajectory Tracking Control of Pneumatic Cylinders with LuGre Model-Based Friction Compensation

Research on Permanent Magnet linear Synchronous Motors Driver for Micro-fabrication

Force Ripple Modeling and Suppression in Permanent Magnet Linear Synchronous Motors

A Simple Force Ripple Compensation Method for Linear Motor Servo System

Research on the Position Error Compensation of Linear Motor

Approach to Calibrating and Compensating Cogging Force Ripple in Linear Motors

Accurate Motion Control of Linear Motors with Adaptive Robust Compensation of Nonlinear Electromagnetic Field Effect

Intelligent measurement and compensation of linear motor force ripple: a projection-based learning approach in the presence of noise

Design and Cooperation Control Analysis of a Coarse-Fine Dual Stage Drive Positioning System

Thrust Ripple Optimization and Experiment for a Permanent Magnet Linear Synchronous Motor

Advanced Motion Control of Hydraulic Manipulator with Precise Compensation of Dynamic Friction

-Synthesis-Based Adaptive Robust Control of Linear Motor Driven Stages With High-Frequency Dynamics: A Case Study

Design of motion controller for precision stage based on tracking error predict

Research on the Control Systems of a Precision Linear Motor Drive Device

THRUST RIPPLE OPTIMIZATION AND EXPERIMENT FOR PMLSM

Force Ripple Suppression for Permanent Magnet Linear Synchronous Motor

Thrust Ripple Suppression Strategy for Precision Machining Platform by Using Predicted Current Sliding Control

Design of Disturbance Observer Based on Linear Motor Precision Stage

Modeling, Identification, and Adaptive Robust Motion Control of Voice-Coil Motor Driven Stages